0
Hourly rates differ from one place to another, but this should not take more than one hour to do.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How much would it cost to replace a clutch on a 99 Chevy cavalier?
The cost to replace the clutch in a 1999 Chevy Cavalier ranges from $100 to $180. This depends on part brand and labor costs.
How to replace clutch 1989 Acura Legend?
In order to replace a clutch on 1989 Acura Legend, you would have to remove the old one. You will do this by removing the jam nut that holds the pedal and disconnecting it from the throttle cable and replace it with a new one.Ê
What would it cost to replace the clutch on a 1993 Toyota Camry?
The estimated cost for parts and labor to replace the clutch on a 1993 Toyota Camry is between $1,260 and $1,687. This can be higher or lower depending on where a person lives.
Does a 2007 corsa have a cable clutch or hydraulic clutch?
A 2007 corsa would be a hydraulic clutch
How do you replace the clutch cable on a 1992 subaru legacy station wagon?
To replace the clutch cable is pretty simple. First put on your e-brake and jack and secure your car. Next, simply unbolt the clutch cable at both ends and remove. To install is the exact reverse. And that's it! I would suggest going to your nearsest auto parts store and picking up a Chilton's manual for your car, it's invaluable for stuff like this. Hope this helps.
What would cause your rm125 dirt bikes clutch not engage?
bad clutch cable, or not enough oil on the clutch plates.
How do you know if you need to replace a clutch cable non hydrolic 1989 Le Baron 5 speed turbo?
If it has stretched to the point where you can't disengage the clutch any more that would be a good sign, also if it breaks of course.
What is the cost to replace a clutch in a peterbilt?
At my shop with clutch and laber it would cost about 1,800
Is the clutch cable or hydraulic1996 corsa?
My old T-reg (1999) Corsa 1.2 Club had a cable clutch. So I expect a 1996 model would be cable. As you look under the bonnet, the clutch mechanism is at your right hand, near the top of the engine.
How would you replace fifth gear syncro or can you just replace the clutch?
5th gear synro is inside the trans... the clutch has nothing to do with it.
What do you do if your clutch is very tight?
First thing I would do is check if its cable or hyd. If it is a cable, check to see if clutch cable housing is not rusted up causing cable to bind up.If pressure plate is warped it could cause it to be stiff
How do you know if you need to adjust your clutch cable or if your clutches are bad if you have to rev up in first gear to make it go?
Sounds like the clutch is slipping and needs to be replaced - if cable was stretched clutch would not disengage and vehicle would creep in 1st gear and shifting would be difficult
