you would be better off to buy a 4x4. Good answer above! It use to cosat approximately $1,000 per axle but that was yesterday's prices. Now you are looking at $3 to $4K to do the job. It's not worth it!
It would not be worth the money to do this task. My opinion is to go out and buy one with 4 wheel drive.
it would be much cheaper to buy a 4x4
Basically, no. It would be much easier to just buy an all wheel drive car.
A stair-lift would be a novel addition.
To pay someone to do this job would not be cost effective. Better to buy a rear wheel drive vehicle and sell the front wheel drive vehicle.
pretty much you dont convert front wheel drive to rear wheel drive it would involve new engine, new transmission, new differential, new drive shaft etc just cost prohibitve and you would have to change suspension and a lot of engineering would be required just buy a rear wheel drive vehicle
That would depend on your engine size ( 2.3 liter 4 cylinder , 3.0 or 4.0 liter V6 ) automatic or manual transmission , 2 wheel drive or 4 wheel drive etc.
That would depend on what size of engine you have , whether it's an automatic or manual transmission , two wheel drive or 4 wheel drive . A little more information please
I would say front wheel drive
The year, make and model info would help.
these rotors are slide on, so the are rusted around hub, you could beat them loose with a hammer or if can use air tools an air chissel with hammer end would do the trick
That would depend on the transmission ( automatic or manual ) and the differential gearing , cab style , 4x4 or 2 wheel drive etc. - more information please It is a automatic transmission - 2 wheel drive. Does this help?