0.63 cents
It will cost between $50 and $100 to fix a small dent in the wall, if you hire a carpenter. An individual can fix the small dent in the wall for less than $20.
Jacob Black helps fix the dent in Bella's truck in the movie "Twilight."
== == == == == == == == == == == ==
It depends on the truck, with traditional steel bumpers it may actually be easier and less expensive to replace the bumper with a unit from one of several vendors such as LMC Truck. Plastic bumpers, which you didn't see much on trucks until recently are a little different and may be reparable but the foam behind them must be replaced if it is compromised. I realize this isn't the simple answer you wanted but really you need to visit a couple shops in your area to get a feel for what needs to happen.
Then you have a dent on your car. If the repair cost is equal to or less than your deductible, then the whole of the cost will be out of pocket.
By the way, the dents were caused by hail and are on the roof.
take a hair dryer to it for 30 sec to 1 mintute then flip a can of air duster upside down spray generously an wait the dent will come out and there is no damage to the paint
The cost to repair a dented passenger door on a Mitsubishi depends on the shop and the dent size. The cost can range from $70 to $200+.
8.50
$800-1800
Paint less dent removal cost is widely variable, and is dependent upon the size of the dent in question. The logic with this is, the larger the dent to be popped out, the more you will have to pay. A dent that is one inch or smaller, in diameter, typically costs between 85 and 100 dollars. But a larger dent that has a diameter of 2.5 inches, will typically cost 150 to 200 dollars. As far as a place to get this done at, any local automotive repair shop should be able to do this for you, and will be able to give a more accurate quote. Hopefully this helps, good luck!
That depends on the severity of the dent. A minor dent could be removed by a paintles dent removal specialist for less than $100. A major dent could involve replacing sheet metal and over $1000.