0
How much would it cost to replace the throttle position sensor on a 1999 Jetta?
Wiki User
∙ 9y ago
The cost to replace the throttle position sensor on a 1999 Jetta depends on whether the engine is gas or diesel. The gas engine throttle position sensor will cost around $100 just for the part. The diesel engine part is slightly higher. Labor costs are around $75 to $100 per hour depending on where the vehicle will be serviced. This job should take about one hour.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you replace the throttle position sensor on 2001 jetta?
by using the proper tools in your case pay someone
How to replace camshaft position sensor for vw jetta 1999?
how to remplace position of oxigen sensor
How do you replace crankshaft sensor on a VW jetta 2.5l 2006?
where is the crankshaft position sensor on 2.5 liter vw jetta
When did the throttle position sensor change in a 97 jetta?
I think 1995. I'm not 100% sure but I'm pretty sure. My jetta seems to accelerate very slow until it hits about 2500 rpms. Do you think this could be my throttle positionsing sensor?
Were is Crankshaft position sensor located?
where is crankshaft position sensor and camshaft position sensor on a 2004 Jetta 2.0 gl
How do you replace a crank sensor on a 2004 jetta?
How_do_you_replace_a_crank_sensor_on_a_2004_jetta
Where is idle speed sensor for vw jetta 96?
The idle speed sensor tells the onboard computer how fast your engine is idling. The location of the idle speed sensor on the VW Jetta is on the actual throttle body.
What is engine code p0322 on a 2002 vw jetta?
Crankshaft Position Sensor (CKP Sensor)
Where is crankshaft position sensor on 2003 JETTA?
Right by the oil filter.
Where is the camshaft position sensor on a 95 Jetta III 2.0L?
Is is located inside the distributor.
What does p1580 code mean on 1999 VW Jetta?
its for the throttle sensor actuator malfunction, you may need to just clean the throttle body and clear the code and see if it goes away
Where is the coil on a 2000 jetta?
it is also throwing a code for the camshaft position sensor. and yes i did have the timing checked
