0
How reassemble the door handle cable on the backdoor E150 cargo van I have replaced the lock but not sure where the cable to the latch goes back onto.?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you get the hood open on your Dodge Caravan the handle moves but nothing happens?
I had this problem on a Chevy; the cable was broken and had to be replaced. Before I replaced it, I was able to crawl under the car and, using a screwdriver against the cable (near the hood latch), pushing against the cable with the screwdriver, the latch released.
How do you replace a Toyota sequoia door handle cable?
This is done by removing the trim on the inside of the door. Then it is neccessary to remove the No1 service hole cover. Then one removes the door lock protector, the door handle protector, and detatch the control cable from the outside door handle. You then remove the door lock wire harness loops, and remove the lock from the door. Detach the old cable and reattach the new. and reverse the steps you just followed to reassemble the door.
How to open a hood with a broken cable?
I had the same problem with my 1995 LHS. The only remedy is to carry a set of pliers in your glove box. I replaced the cable handle once but it broke again.
Driver side front door does not open from inside on 2002 ls?
Interior door handle plastic wears at the connection point to cable. Interior handle assembly needs to be replaced. Original is riveted in place.
How do you repair the hood latch for the 1991 Mercedes 190E 2.6 the handle in the car that opens the hood does not work it does not pop the hood?
The hood is openned by a cable that links the handle in the car the hood latch. If the cable is broken or detached then the hood will not open. The cable has two parts, an outer covering and the actual cable that pulls on the hood latch when the inside handle is pulled, you need to check the inside handle to see if the cable is still attached to the handle, also you need to check the hood latch to see if that end is still attached to the hood latch. If either is disconnected the you will need to get appropriate hardware(nuts,bolts etc) to attach it back but if the cable is broken it has to be replaced complete. This you might or might not be able to do depending on you skill and proficiency with tools.
How do you fix backdoor lock on 2000 f150 ford?
How do you fix the cable in side of the back doors of a 2000 ford f150
How do you repair the connector on a gear shift cable?
Usually, the complete cable must be replaced.
How do you fix a broken hood release on a Ford Windstar?
AnswerIf it is just the plastic handle broken, behind that is the cable that opens the hood. Just grab the cable with a pair of pliers and pull. You can probably just replace the inside handle and not have to run a new cable. AnswerI assume the handle broke off in the car. You will have to by a new cable/handle assembly ($30.00) so I would: Cut the remaining handle and end off the cable housing so you can get at the inner cable core. Then take a vise grip and pull on the inner core to release hood latch. New housing/cable assemblies are available at your Ford dealer.
What is the hard drive data cable?
There are two, an IDE Cable which is an "older style" that is gradually being replaced by the SATA Cable.
Can you fix a 2001 Jeep Grand Cherokee throttle cable?
The cable must be replaced if damaged.
Can the broken hood release cable for a 1996 Jeep Cherkee Sport be reattached at the pull handle by crimping it together?
Yes you can crimp the hood release cable back to the handle.
How do you replace the cable in the door handle of a 2002 sequoia?
get a BFH
