I'd wait for at least a 150 miles ... if you have it checked too soon, there won't be enough stored data for the system to relay to the smog check machine.
It has to be done with a scan tool. Resetting the light without correcting the problem will be of no use as the light will come back on.
After repairing the cause of the code, you clear it with a scan tool.
A blinking check engine light means an engine cylinder misfire has been detectedNot only a misfire, but a condition that could cause a catastrophic failure of the catalytic converter. The injector on the effected cylinder(s) will be shut off by the PCM
The engine light will only be on because there is a problem, take it to your nearest Audi Speacialist Cars where they can plug it into a machine and check what the problem is. it could be a case of just a failed sensor somewhere in the engine but more than likely will be a problem, not something you want to ignore!
in front of the engine check this file https://sites.google.com/site/autobestanswer/audi
I had that problem on the freeway outside of Boise in my '85 4000s. Turned out it was the distributor, which had shattered on the inside. Other than that, I'd check the EFG valve.
Audi A4 1999 1.9TDi Oil pressure light on continously. Engine sounds fine. How do I remove electrical connector to remove switch and check pressure with a gauge?
There are a multitude of reasons why the check engine light could come on - you need to have an OBDII scanner hooked up and pull fault codes to determine the cause. As for resetting it, fixing the problem which causes it would be the best way to go.
Check the engine code using a code scanner. That will give you the best information.
The Audi mechanic is referring to the fact that the "check engine" light is an integral part of the emissions control system. If the engine runs and the check engine light is on, it means that a sensor or other emissions system device is not functioning properly. When the computer detects a 'fault', it turns on the light to inform you that the vehicle needs to be repaired. The NEXT step is to connect the vehicle to a code scanner so you can figure out what's wrong. You can borrow, rent or purchase a code scanner at most auto parts retailers. It's impossible to list all of the possible problems that would cause the light to come on. Fortunately, the computer can tell you.
only way to turn off an ABS light is to fix the problem in the brake system that originally turned the light on
Black smoke means the engine consumes too much gas - possible problem with fuel injection. Is your check engine light on? It could also be a problem with oxygen sensors.