Pry off the kick panel. Then pry out the soft rubber cover that is under the kick panel that covers the opening. This will give you access to the back of the check link assembly. Remove the 1 bolt that holds the unit to the door and then remove the 2 nuts that hold the unit to the door jam. Reach in through the opening in the kick panel area to remove the old unit. Save the rubber seal, 2 nuts and 1 bolt. Insert the new unit through the opening in the kick panel area and hold in place. Put the rubber seal on and then put the 2 nuts on and tighten. Use pliers to extend the bar that attaches to the door and secure using the bolt. Replace the rubber cover and kick panel.
2003 SATURN L 300 front axle torque spec
Is this the front assembly or the rear? I can't say for sure on the rear, but on the front, you will need a very large socket for the nut at the outside of the hub assembly. I don't recall for sure, but I think it's like 30mm. Check before you buy a socket for it, as they are expensive. Also, you may want to have a pickle fork to break the ball joints loose up front. Aside from the large nut at the outside of the hub assembly, the largest wrench you will need is 19mm. If you can find a Chiltons manual for a Saturn SL, it will walk you through the entire process of removal and re-assembly. . Found this link to change a Saturn S-Series front hub. It worked perfectly as all the pictures were extremely helpful. I actually pressed new bearings into to the existing hubs which is not recommended by Saturn but worked out OK for me. http://www.xwarlordx.com/twin_cam/tech.html
check links below: front: http://www.youtube.com/watch?v=CsUn9m4Y4_0 rear: http://www.youtube.com/watch?v=FpxQN2esZnU
grab an alen wrench and remove the hexhead bolts on hub. assembly should pull right out. pop the new ones on tighten up. be sure to check gear oil.
The TIE ROD on your Saturn connects the rack and pinion assembly to the wheel assembly, enabling you to steer the car.A worn tie rod will result in loose steering, excessive shaking of the front wheels, erratic steering and poor steering control.
You can change the front wheel bearings on your 2000 Buick Regal without replacing the entire hub assembly. You can change each individual wheel bearing, if you choose.
If by front corner panel you mean the panel above the tire then check out the related links below.
Rear you have to change the entire hub assembly Front you have to remove the axle shaft
How do you change the front brake pads on a Ford E-250 van? cannot remove the pads from assembly.
rear you use a torx driver to remove taillight assembly screws. them replace bulb.
Have someone check the auxiliary steering shaft.
Front Line Assembly was created in 1986.