Nissan Altima
Timing Belts and Chains
Ford Ranger XLT
How To

How to change timing belt on 1996 Nissan Altima?

141516

Top Answer
User Avatar
Wiki User
Answered
2010-04-06 14:40:44
2010-04-06 14:40:44
Answer to timing belt for 1996 AltimaThey don't have timing belts. At least mine doesn't. Double check your manual or call a Nissan dealer & ask to be sure.

There is not a timing belt on this model or any year before or after this model. You have a 2.4L engine with a timing chain and there is no reason to replace the timing chain unless it is making noise. The chain is at least rated at a 7-10 hour job and should not be considered for repair due to the damage that can arise if not careful.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Where is the fuel pump located on a 1996 Nissan Altima

The EGR valve on a 1996 Nissan Altima is on top of the engine. The air filter box has to be removed to access the valve.

overheated and wont start

You dont they are meant to be in the car for the life of the engine. But you can buy a timing light and check the timing.

What should you do when the enigne light comes on in the nissan altima 1996 and how should i go about fixing what does it need?

On my 1996 Nissan altima the oil sending unit is located above the oil pan and below the oil filter on the passenger side of the vehicle.

NO , try 2007 for the in cabin filters to show up in an Nissan Altima.

Yes it has a timing chain not a timing belt.

The 1996 Nissan Maxima timing marks can be found on the main pulley, on the front of the engine. The timing marks will be scattered around the outside of the pulley.

The 1996 Nissan Maxima 3.0 liter V6 engine must have a timing CHAIN because the Gates website does not list a timing belt for it

The thermostat on the Nissan Altima should be directly behind the alternator. This will be on the passenger side of the car and directly under a large heater hose.

It takes 15.9 gallons of gas to fill up a 1996 Nissan Altima. The Altima is able to reach up to 150 horsepower at 5,600 rpm.

The fuse box for a 96 Altima is located under the dashboard by the brake pedal.

Most voltage regulators are inside the alternator.

The 1996 Nissan Altima takes 21" drivers side and 20" passenger side replacement windshield wiper blades. See sources and related links below for more information.

http://www.nissanclub.com/forums/general-nissan-altima-discussion-1993-2001/260207-how-change-headlight-bulb-96-nissan-altima.html Copy and past that into your web browser. Its for a 1996 but it should be close. I know the bulb is different so look up what bulb you will need. Other then that the steps should be really close.

for Quarts of Oil for 1996 AltimaI just did this and used 4 quarts of 10W 40...Hope this helps.

could be your thermostat is stuck or perhaps and needs to be replaced.

Proper tire pressure is recommended for safe driving conditions. Low pressure can lead to lost of traction and increased braking distance. The standard recommendation of tire pressure on a 1996 Nissan Altima is 32 psi.

8 to 8.5 quarts including reservoir

Knock sensorThe knock sensor for a 1996 Nissan Altima is located on the backside of the block above the oil filter.But before you go and change it out, run a tank of the best/hightest rated gas you can find and see if that fixes the problem. On my 1995 the Knock sensor is located under the plenum and intake manifold on top of the middle of the block.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.