Removal & Installation
# Before servicing the vehicle, refer to the Precautions section. # Disconnect the negative battery cable. # Drain the engine cooling system. # For 5.3L engines, loosen the air cleaner outlet duct clamps at the throttle body and Mass Airflow/Intake Air Temperature (MAP/IAT) sensor. Remove the bolt and air cleaner outlet duct. # Relieve the belt tension and remove the accessory drive belts or the serpentine drive belt, as applicable. # Remove or disconnect the following: NOTE
For the hoses on some engines, removal may be easier if the hose is left attached until the pump is free from the block. Once the pump is removed from the engine, the pump may be pulled (giving a better grip and greater leverage) from the tight hose connection.
WARNING
Note the positions of all retainers as some engines will utilize different length fasteners in different locations and/or bolts and studs in different locations.
#* Upper fan shroud #* Fan or fan and clutch assembly, as applicable #* Water pump pulley; use a suitable tool to hold the pulley while removing the bolts #* Coolant hose(s) from the water pump #* Water pump retainers #* Water pump from the engine Exploded view of the water pump assembly mounting-4.2L engine
Exploded view of the water pump assembly mounting-4.3L engine
Exploded view of the water pump assembly mounting-5.3L engine
To install: # Clean the gasket mounting surfaces. NOTE
The water pumps on some of the engines covered may have been installed using sealer only, no gasket, at the factory. If a gasket is supplied with the replacement part, it should be used. Otherwise, a 1/8 in. (3mm) bead of RTV sealer should be used around the sealing surface of the pump.
# Apply sealant to the water pump retainer threads. # Install or connect the following: #* Water pump using a new gasket. Tighten the water pump retainers to 89 inch lbs. (10 Nm) for 4.2L engines, or to 30 ft. lbs. (41 Nm) for 4.3L engines. For 5.3L engines, tighten the bolts to 11 ft. lbs. (15 Nm), then to 22 ft. lbs. (30 Nm). #* Coolant hose(s) #* Water pump pulley. Tighten the pulley bolts to 18 ft. lbs. (25 Nm). #* Fan or fan and clutch assembly #* Serpentine drive belt (if equipped) by positioning the belt over the pulleys and carefully allow the tensioner back into contact with the belt. #* V-belts (if equipped) and adjust the tension #* Upper fan shroud #* Negative battery cable # Refill the engine cooling system. # Run the engine and check for leaks.
replace water pump 2005 chevy trailblazer vortec 4200
how do you get a water pump off on a 2005 trailblaxer 4.2
The thermostat, on a 2005 Chevrolet trailblazer, can be replaced by first removing the water hose. Next, remove the three housing bolts. Take the thermostat out and replace with a new thermostat.
We have complete instructions at our enthusiasts forum at www.trailvoy.com
Timing chain, no maintenance required.
no
do a 2005 trailblazer come with a carentry control
how to adjust the seat memory on a 2005 trailblazer
will 02 03 04 Chevy trailblazer doors fit a 2005 Chevy trailblazer The body style is the same from '02 to the end of production in '09. Side moldings changed over the years and are just glued on.
We have a "How To" at our enthusiasts forum! It's free and run by true enthusiasts! www.trailvoy.com
There is none
6