Assuming you are going to replace the drum along with the rest of the brake parts, just go ahead and beat on the drum with a large hammer and spray some penetrating oil. It will come loose eventually. Backing off on the brake adjustment may help also.
Its got disc brakes in the front, therefor brake pads and its got drum brakes in the back, therefor brake shoes
How do you change rear brake drum on a 2004 Chevy Venture?
you get a towel and clean
i need a diagram of a 2005 Chevy silverado read drum brake setup
8"
14 mm
yes
Brake drums can be resurfaced by turning the brake drum in a brake drum lathe. When the brake drum has deep grooves in it, it cannot be repaired.
A drum brake is a brake that uses friction caused by a set of shoes or pads that press against a rotating drum-shaped part called a brake drum. The term drum brake usually means a brake in which shoes press on the inner surface of the drum.
First off, you need to take any tension out of the parking brake cable. If it is still siezed up you need to work the parking brake actuator back and forth at the wheel until it frees up. If it is still siezed up hit the brake drum with a large hammer as you pull on on the drum. If it is still seized up take cut the drum off with a torch.
Look at the two cable going to each drum to see if just one is stuck on or both. IS it drum or disc? It is the emergency brake cable. It happened to me once before and the tow truck driver said the release is the same as in a Cadillac, but that doesn't help me and I can't afford another tow truck driver. In a caddilac you put it in drive to release the parking brake. But when the cable is broken you can't engage the parking brake.
A drum brake is a brake that uses friction caused by a set of shoes or pads that press against a rotating drum-shaped part called a brake drum. The term drum brake usually means a brake in which shoes press on the inner surface of the drum.