I have done this three times, and it is pretty easy. First you need to drop the exhaust from the exhaust manifold, then drop it the rest of the way up till the catalitic converter is off. next, take off the drive shaft by taking off the four nuts located on it,( you most likely need to disconect the emergency brake and drop the bar located in front of the rear axle, its only four bolts). then after the driveshaft is out, disconnect the transmission mount by the shofter on the bottom side, then diconnect the bolts from the bell housing.(also, don't forget to disconnect the battery and drop the starter first, and disconnect any wires connected to the transmission and the speedometer cable).
First, what year and car are you asking about? 1987 Nissan 300zx
Where is the ignition control module on a 1987 nissan 300zx
If they both have the same engine.
penis
Yes it will find one that is a 86 to a 88 or 89 will work for you.
5 quarts of oil
To install a thermostat on a 1987 Nissan 300ZX, remove the two nuts and one bolt on the lower water neck. Slip off the old thermostat and use a gasket sealant to secure the new thermostat.
Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced. Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced.
Remove the radio and the fuse is behind the radio
The fuel tank capacity is 19.0 gallons i have an 87 300zx and it only has an 8 gallon tank.
I have 255,000 on a 1987 Nissan 300zx and still running strong. As long as you maintain the car and change the oil evry 3000 mi it should last a long time.
In the thermostat housing on the front of the engine were the radiator hose attaches