Heater Cores and Blower Fans
Pontiac Bonneville
How To

How to install heater core on 1996 Pontiac Bonneville?

363738

Top Answer
User Avatar
Wiki User
2007-04-20 02:55:13
2007-04-20 02:55:13

You don`t want to go there !( Trust me.) Take it to a radiator shop.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

'How do you change a fog light in a 1996 Pontiac Bonneville? ... How do you

User Avatar

How to remove left inner door panel of a Pontiac Bonneville 1996

User Avatar

diagram for serpentine belt on 1996 Pontiac Bonneville se

User Avatar

I have a 1996 Bonneville and it has a Phillips head screw on each side of the armrest. If yours is like that then you should be able to just unscrew them and pop it out.

User Avatar

If the Bonneville is like my GTP then the fuel filter is in front of the fuel tank

User Avatar

A 1996 Pontiac Bonneville requires 5.7 quarts of oil in the crankcase. The oil filter should also be changed with the oil.

User Avatar

You need to take of the door panels!

User Avatar

I own a 1996 bonneville. The tensioner bolt is a reverse threaded bolt, (tighten to loosen). Hope this helps. DCC

User Avatar

On my '95 Bonneville the trunk release button is on the driver's door below the door handle. Hope this helps.

User Avatar

Go here for your answer: http://www.cardomain.com/memberpage/338233/4

User Avatar

It is located top left of the motor if you are looking at it from the front bumper

User Avatar

Under the steering wheel, probably on the left side near the door panel.

User Avatar

po 302 is not a valid code but maybe misfire code number 2 cylinder

User Avatar

behind the power steering unit on the oil pump housing above the oil filter

User Avatar

If it's the same as a '98 Bonneville SSE 3.8, it's - 1 4 5 2 3 6 If it's the same as a '98 Bonneville SSE 3.8, it's - 1 4 5 2 3 6

User Avatar

You have a bad relay. Your blinkers run on a different relay than you hazards do.

User Avatar

That code is a transmission slip same code came on with my 96 Cutlass Supreme

User Avatar

unclip the old one, unscrew it. then screw in the new one and clip the new one on

User Avatar

The 1996 GMC half ton pickup truck heater core can be removed by removing the heater core retaining bolts. Remove the heater core water lines. Reverse the process to install the new heater core.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.