Hold the outside two buttons to clear the memory. Then hold in the button you want to program and the remote button to learn from at the same time. The blinking should change to a faster pace. No idea what makes this part happen. I must have done this step 50-100 times before it picked up my remote (maxim_83: this may depend on the learn-from-remote-control, but pressing and releasing the learn-from-remote-control as opposed to just holding it helped really well in my case; my maxima remote picked the signal up in seconds). After it picks up the signal, push the learn button on the garage opener. Then, push the visor button you programed. The garage opener light should flash and you will be done.
A good idea would be to unplug the opener while you are trying to learn the code. I didn't and the repeated attempts overheated the opener. It's also less anoying to not have the door opening and closing a million times.
Eventually, I was able to program both my garage doors. I still don't know what makes a difference. I didn't see any advantage to holding them both the 90 secs like they say it may take. Seems like the times it did finally take, it was in the first 15 seconds. I think it must be the newer frequency openers, because I had no problems with the older Craftsman openers. Thanks to the Nissan Forum for this
This link explains the programming process- http://www.homelink.com/programming/programming.taf
2003 nissan altima visor garage door opener progarming
If it is a homelink system (factory) the proceedure is in the owners manual. You will need an operational opener for your garage.
Google the question: how do I program a 2011 Nissan Pathfinder garage door opener and it will send you on a mobius strip dearch and ask you to answer the question... how stupid.....
how do you program your garage dorr opener to your Volvo 2001 v70
How do you un program garage door opener
program garage door opener for honda ridgeline
no
how do I program a garage door opener for a 2002 chevy venture
To program your on-board factory garage door opener on your Maxima's visor, you first have to press and hold the first and third (outer two) buttons down at the same time for about 15 seconds without letting them go. Then, the middle button's red light will start to flash. When this happens, let go of the two outer buttons and immediately get your original garage door opener and hold it right near your visor, aiming it right at the three buttons. Press and hold the middle button down for about 5 seconds while you simultaneously press and hold your original garage door opener's button down for this same amount of time (5 seconds). After this process is complete, wait a few seconds and you should now be able to use this middle button as your "new" garage door opener!
how do you program my garage door opener in 2009 gmc yukon
how do i program my garage door opener to work with my 2006 dts cadillacqe