answersLogoWhite

0


Best Answer

The wire connector has a clip on the side of it, follow it from the wire side onto the unit, it will end just on the sensor side, lift it up slightly while pulling the wire connector back.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How to pull wire off of 1999 wrangler oil sending unit?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the oil pressure sending unit in a 1999 wrangler Sahara?

the oil pressure sending unit on 1997 and up to 99 wrangler tjs and saharas are right above the oil filter i believe which is located on the left hand side of the block.


Where is the fuel sending unit in a 1993 jeep wrangler?

In the fuel tank


How do you change the oil filter sending unit of a 1999 suburban?

How do you change the oil filter sending unit of a 1999 suburban?


Where is the oil sending unit on a 2001 wrangler with a 6 cylinder?

Right down by the oil filter.


Where is the oil pressure sending unit on a 1992 Jeep Wrangler-4 cylinder?

under the hood


How do you replace oil pressure sending unit on 1999 wrangler 4.0 liter?

on the passenger side of the engine there is a 5 inch or so black plastic unit near the bottom. All you have to do is unplug the sensor from the back and unscrew the unit. They run about 28 bucks at autozone.


When key is turned on the oil pressure gauge on a 1993 jeep wrangler goes above 80 psi even when not running is this a short or a faulty oil sending unit?

Faulty sending unit.


Where is your Temperature sending unit on your 91 Jeep Wrangler?

On top of the divers side of the engine, toward the rear of the engine. Next to the valve cover. There will be a wire running from the wire loom to the sending unit.


How do you replace the fuel pump on a 1996 dodge avenger?

Drop the tank pull the sending unit and the pump is in the sending unit to swap u might have to replace the hole sending unit to be able to get the pump


How do you fix a 1993 Jeep Wrangler Sport temperature gauge that shows overheating when engine isn't overheated even after the oil sensor sending unit has been replaced?

Its not the oil sensor sending unit. More than likely its a bad connection at the temperature sending unit. I have a 95 wrangler that was reading 260 degrees. I had a couple bare wires touching at the temp sending unit. Fixed the wires and all better now. Otherwise its probably the gauge itself.


Where is the temperature-sending unit for a 1999 Ford Taurus?

The temperature sending unit on the 1999 Ford Taurus v6 is on the rear of the engine. It is closer to the driver side about 7 inches down.


What would cause the gas gauge on a 1999 Chevrolet Malibu to not work?

Check for power and ground to the sending unit . If you have that then ground the sending unit and see if it works.If the gauge works then the sending unit is defective.