The temperature sending unit on the 1999 Ford Taurus v6 is on the rear of the engine. It is closer to the driver side about 7 inches down.
AnswerCoolant LEVEL sensor - Located on the bottom of the coolant reservoir.You can see two wire connector protruding towards the fender-side.It is built into the reservoir tank bottom so whole unit gets replaced.See "Related Questions" below for the location of the engine cooling fan sensor and the temperature gauge sending unit/sensor.
The pcm of a 2001 Taurus should be located under the hood. The unit is bolted onto the firewall on the passenger side.
how to take off a air conditioning unit on 96 ford taurus
The coolant temperature sensor is located near the thermostat housing. The sensor is gray and sits alongside of the temperature sending unit(for your gauge) which is usually brown.
The temperature sending unit it on the front of the engine. It is on the top just beside of the water intake.
did you check the kick down cable connected to your transmition to your carb or fuel injection unit? the main purpose of the kick down cable is it tells the transmition to shift when you accelerate the car.i had the same problem to my Ford Taurus. don't try to do it yourself! take it to the shop! See if that's the problem. Aloha
wher is the oil sending unit for a 1999 ford f250 v10 triten located on moter
I have a Ford Taurus 92, and my cruise control is right on the steering wheel. There is an "on and off" switch on the wheel, and you click the on, and a cruise control button should be under those. (be sure to click "on" before you click the c.c.)
It is usually located next to the oil filter.
For the DOHC motor look behind the dipstick tube for a single wire sensor.
where is the temp. sending unit located on a 1999 ford ranger xlt 6cyl 3.0l .Gauge does not work.
in the tank, same unit as the fuel pump, it is a bad design