0
Where is your Temperature sending unit on your 91 Jeep Wrangler?
Wiki User
∙ 14y ago
On top of the divers side of the engine, toward the rear of the engine. Next to the valve cover. There will be a wire running from the wire loom to the sending unit.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the fuel sending unit in a 1993 jeep wrangler?
In the fuel tank
Where is the oil pressure sending unit on a 1992 Jeep Wrangler-4 cylinder?
under the hood
How do you fix a 1993 Jeep Wrangler Sport temperature gauge that shows overheating when engine isn't overheated even after the oil sensor sending unit has been replaced?
Its not the oil sensor sending unit. More than likely its a bad connection at the temperature sending unit. I have a 95 wrangler that was reading 260 degrees. I had a couple bare wires touching at the temp sending unit. Fixed the wires and all better now. Otherwise its probably the gauge itself.
How do you fix the coolant temperature gauge on a 95 Jeep Wrangler YJ model 2.5L engine?
The sending unit is screwed in the head. Check to make sure the wire is attached and if it is, change the sensor.
Where is the oil sending unit for a jeep wrangler?
right where the oil filter is, its that wire that gives you trouble when you try to replace the filter.
Where is the oil sending unit on a 2001 Jeep Wrangler with a 6 cylinder?
It is in the oil Pan. You will have to drop the oil pan to change it.
Does a 1997 jeep wrangler have an oil sending unit if so where is it?
Yes. www.autozone.com component location. NEXT TO THE OIL FILTER.
When key is turned on the oil pressure gauge on a 1993 jeep wrangler goes above 80 psi even when not running is this a short or a faulty oil sending unit?
Faulty sending unit.
Where is the oil sending unit on a 1997 Jeep Wrangler 4 cyln?
Attached to the underside of the motor, accessed by removing the oil pan.
Where do you find an oil pressure sending unit in a 1995 Jeep Wrangler YJ?
Right next to the oil filter, it kinda gets in your way when you are replacing the filter.
Where is the oil pressure sending unit located on 1989 Jeep Wrangler?
If you have the 4.2, it is on the passenger side of the engine near where the dipstick enters the block, forward of the starter.
How do you replace fuel gauge sending unit on 1998 jeep wrangler se?
1997-2206 JEEP TJ Wranglers have the combination fuel pump assembly and fuel gauge sending unit located inside the gas tank. The gas tank needs to be unbolted and removed to access the fuel pump assembly.
