check this out, it's same engine as in Rabbit http://rabbitownersclub.com/vw/showthread.php/engine-plastic-cover-4981.html
6.2 quarts with a filter change
1-25-08 As of right now the Jetta sportwagen should arrive in the U.S. in either the middle of summer, or in early fall 2008. The model will be available in a 5 cyl 2.5 liter engine, a new clean diesel engine, or possible the 2.0 turbo engine. This model will be a 2009 model. 1-25-08 As of right now the Jetta sportwagen should arrive in the U.S. in either the middle of summer, or in early fall 2008. The model will be available in a 5 cyl 2.5 liter engine, a new clean diesel engine, or possible the 2.0 turbo engine. This model will be a 2009 model.
It's IN the oil pan! You need a 7/8" wrench and some muscle. Remove the cover and you'll see it in the hole.
your best bet is 25'' ('' is inches)
5-10-15-20-25-30
You must first remove the cover from behind the door open lever and the cover from the door handle....then remove the screws.... then remove the cover for the mirror that's on the inside its snaps off so a firm pull should do the trick, and then the same for the door it has like 20 or 25 snaps that all have to be undone... a quick pull will snap it out and then I'm sure you can figure the rest out :-)
It is on the top side of the engine to the right of the motor cover. You will see a round black plastic can with a 27mm hex head on top to remove the top. You torque it to 25 ft lb when you reinstall it. Kia filter #26320-3CAA0
The Water Fuel Separator is located in the V of the Engine. You can remove the decorative cover over the water fuel separator. as you are facing the engine on the bottom back left side is the valve. slide it to the right Open the hood. Place an appropriate container under the filter drain under the vehicle. Locate the fuel filter drain valve. If necessary, remove the engine appearance cover. Open fuel filter drain valve by turning clockwise. Allow to drain for approximately 25 seconds or until clean fuel is observed. Close filter drain valve by turning counterclockwise until firmly seated. Verify that the fuel filter drain valve is closed. If removed, install the engine appearance cover. Close the hood and remove the container from under the vehicle. Restart the engine and check WATER IN FUEL indicator light. The light should not glow. If it continues to glow, have fuel system checked and repaired
onda engine was in the rover 25
Changed camshaft position sensor, about $25, top back of engine at end of valve cover. Engine revs to 4500 and seems to have a lot more power. Took about 5 minutes to replace!
The horn relay (there are actually 2) are located in the engine compartment. When you are looking into the engine compartment from the front of the vehicle, there is a black cover on the left side. They are under that cover, are normally brown, and normally both go at the same time. They run about $25 or so at AutoZone or Advanced Auto.
remove right side under dash panel remove blower cover unplug motor remove motor and blower regulator swap regulator on to new motor note all u need is a philpps head and a 15 and 25 torques