0
You have to first remove the plastic cover that makes up part of the inside panel. It's the panel that receives the seat belt. This is probably the only tricky part. Once you get that off, simply locate the bolts that hold the seat belt system in. Unscrew them and take out the entire system. A dealer wanted to charge me over $100 to do this. What a scam.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Did the 1957 Chevy have seat belts?
No, the 1957 Chevy didn't come with seat belts.
How do you fold down the back seat in a 2003 Chevy Tracker?
2002 has a pull cord at the back of the seat(by the seat belts) which unlocks the bottom to fold forward then the back folds down with the button release by the head rest... hope this helps
How do you remove the front seats from a 1999 Chevy Tracker?
Unbolt them from the floor. First remove the plastic covers (they pop off) then remove the four bolts holding the seat down. There's one on each corner. Disconnect the seat belt sensor wire before pulling the seat out of the car.
What seat belts from other vehicles fit 83 Chevy truck k 20?
any seat belts from an 1981 through1987 Chevy truck or 1981 through 1989 blazer or suburban
How many seat belts in a 2009 Chevy Malibu?
2 in the front seat 3 in the back
How do you remove the backseat of a Chevy beretta?
On a 96 beretta there are 2 bolts just under the front edge of the seat. Then after you remove the seat bottom there are 2 torx bolts (don't remember the size)holding the seat back and seat belts. After you remove the 2 torx bolts then you pull the seat back up to unhook the top of the seat back. torx T50
How do you install seat belts in a 1973 Chevy El Camino?
That vehicle had seat belts in it when it left the factory so it should have threaded holes in the floor where they were once mounted. Purchase aftermarket seat belts for that vehicle and bolt them in.
How do you replace rear seat seat belts?
order new belts from an OEM supplier with new bolts and washers. remove rear seat and go to work!
Remove rear dash plate on 2004 Chevy cavalier?
2 Dr models, You must start with the door kick panels then remove the seat belts then the rear side panels then you can go after the rear dash.
1954 Chevy bel air do you need selt belts?
You do not need seat belts if your car was originally manufactured without them, and they have never been installed. At any time seat belts are installed, they must be maintained for the lift of the car.
How do you remove the back seat from a 1999 Dodge Intrepid?
well the first thing is to remove the lower seat. It has two clips near the front of it . Remove the lower seat now. Next remove the side panel right above the back seat. Now you have to remove the bolts for the seat belts, it holds the back part of the seat in. move the back part of the seat up towards the back window. You should hear the seat come loose. Now when you put the seat back in don't forget to pull the seat belts back though.
How do you remove the seat cushions on a 1991 Chevy Corvette?
== ==
