This explains it very well. It also explains how to change the dash to an older CJ style dash.
http://www.jeepforum.com/forum/f12/yj-cj-dash-swap-write-up-pictures-634392/
I need to know asap how to remove a trasmission oil pan on a 1991 jeep Cherokee Laredo? Thank you!
A 1991 Jeep Cherokee computer is what fits a 1991 Jeep Cherokee.
These jeeps have a metal plate, and then a rubber bumper cover is bolted onto the plate. There are two bolts on either side of the bumper cover (on the inside of the bumper cover). Taking the cover off requires a ratchet. Taking the plate off requires a bit more work, as there are more bolts to contend with, as well as the skid plate, etc.
Look at the other question about the 95 yj, it's explained there... lataaaaaaaaa
remove access plate on floor around shifter, 4 bolts hold the shifter onto the trans.
Yes. A 1991 Jeep is fuel injected.
i have a 1991 jeep laredo 2 door.like to find a new door for drivers side...does the 4 doors have the same size...and what years if so.....thank you Vince vcal37@yahoo.com
under the skid plate take it off and all will bee seen?
changing the ignition switchfirst you have to take the steering wheel off.then you have to to have a tool called a steering wheel lock plate remocer/installer to remove the plate under the wheel .then you need to remove the turn signal switch (there is four screws holding it in , remember how you take it off )after that you have a little torx screw that you remove so you can slide the ignition out of the column .use the same directions in reverse to put the system back together with the new ignition switch
Just pry it out to you. Work around it until it's out. Start at the bottom edge.
Transmission, yes Motor no, but it would be easier if it was out.
Yes.