the Power Steering pump has a 3 bolts that lock it down lossen them up and behind the pump you will see a tension bolt its lond and threaded with a nut on the end loosen that up the power steering pump will slide down a bite just enough to take the old belt off but remember of how it goes on so you dont screw up the new one
180 to 200lbs
Remove serpentine belt, alternator, and power steering pump. Remove 4 water pump pulley bolts. Remove water pump housing bolts. Remove water pump.
Probably not. What you will do is remove the fan first, and then the fan shroud. The reason for removing the shroud is so you have more room to work.
Replacement of the harmonic balancer is most conveniently done with the engine out of the car. 1. Release the belt tensioner and remove the serpentine belt. Take note of its routing. 2. Remove the bolt from the center of the balancer. 3. Use an appropriate puller to remove the balancer from the crankshaft. 4, Use the center bolt to pull the replacement balancer onto the crankshaft. Replace the serpentine belt.
no u do not
To change the positive battery cable on a 1988 Jeep Cherokee trace the end of the cable to the starter. Unplug the battery then remove the cable from the starter. Measure the old positive cable with the new and be sure to replace the unit at the right size.
you have to remove the studs, or remove the entire intake manifold! when you do finally get it off replace the studs with bolts.
Remove the oil pan and there it is...
no, you do not need a compression tool to remove or replace them
Remove steering wheel, turn signal (4 screws), and torx holding ignition, reverse to reinstall.
Pictures of the steps, especially the "keeper", would be handier than random pictures of Jeeps. You have to drop the transmission, remove the throwout bearing/slave cyl, replace it, re-install the trans, bleed the system.
with a hammer