Yup happend to me too. See on the Auto tran there will be a cable that run from the Tran to you Stearing weel(in side the car remove the bottom dash to get to it) a black cabble, there is a bolt that hold it in (mine fell out) There for the tention of the cable is sloppy and will not release you key easy fix 20 min top and that if you take you time in case u must get it out ASP with out the fix slam the car from drive to park and shake the key out (I am a master at that)
how to remove key stuck in ignition switch in Chevy colbalt
there is a problem with your bcm or body control module, have it checked
Check the belt on your alternator. If it is not tight enough it will squeal on a Rodeo. Be sure to get it checked soon or your belt could fall off or burn up your alternator and then you are stuck!!
change you thermostat it is stuck open or not closing fully. This allows the coolant to circulate to quickly.
remove battery cable
Damaged ignition switch which keeps power constantly to the start circuitFaulty starter relay which keeps the contact closedShort in the starter solenoid keeping the circuit closedPositive and negative wires making contact at the solenoidThose are all possible reasons
There should be a lock on the ignition a push button that you push and turn to remove the key
To remove a key that is stuck in the ignition on a Peugeot 406 HDI, make sure that the car is in park. Then try to remove the key. If this does not work, spray the ignition mechanism with WD-40 after pulling out the key as far as possible. Then work the key in and out until it comes out.
Well, it sounds like the chip that is in your key may have broke or got stuck on a part of the ignition. I had that problem. This happened not long after I had had to have the ignition replaced?!?
I had this problem, the stick-shift was not fully in the 'park' position try and jiggle the stick.
See You-Tube Video : http://youtu.be/lBNUuO4ldfI How to Remove a broken key from an Ignition. Using the Broken Key Extractor Kit from: www.WedgeCo.com
Use the opportunity to replace the ignition. Key needs to be in On position for removal.