answersLogoWhite

0


Best Answer
Removing starter, 90 Chevy berettaThis one is actually quite simple. Looking straight down at it, you can see the wires running to the solenoid and the starter itself. Disconnect the negative terminal on the battery before doing anything to prevent any accidents. If memory serves me right, you'll need either a small wrench or socket to loosen the nut holding the wires to the starter. Disconnect those, and set them aside. Now, looking up at the starter from underneath, there are two larger 15mm bolts that connect the starter to the block. Simply loosen those (smaller one in front first) and be careful: the starter is a lot heavier than it looks! From there, installation is just reversed. Make sure not to overtighten or strip those mounting bolts. Otherwise the gear inside the starter won't hit the flywheel properly or at all, and you'll end up stripping that gear, leading to replacement all over again. Reconnect the wiring, making sure everything is where it was to begin with, reattach the terminal on the battery, and let her rip!
User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How to remove the Starter from a 1990 2.2L Chevy Beretta?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a 1990 Chevy Beretta battery?

how to replace a 1990 Chevy Beretta battery


Where do you get a right rear strut assembly tower for 1990 Chevy Beretta GT?

There are no rear struts in the Chevy Beretta. Only shocks.


Where do you find a replacement dashboard top for a 1990 Chevy Beretta GT?

Ebay. Just enter Chevy Beretta under parts and accessories


Where is starter solenoid on 1990 Chevy Cavalier?

It is bolted to top of starter.


Where is starter solenoid on a 1990 Chevy Silverado?

It is mounted on the top of the starter.


How do you change the starter on a 1990 Chevy Corvette?

== ==


Where is the solenoid on the 1990 Chevy s-10?

If you are looking for the starter solenoid, it is attached to the starter.


Where would a starter be in a 1990 Chevy Lumina?

I just replaced the starter motor on my 1990 4 cylinder engine Chevy Lumina. The starter is located in front of the oil pan. It was reachable and can be seen from under the front of the car a little to the right. You have to remove a three bolt attached plastic part by the oil pan to be able to get to one of the starter motor bolts. Good luck.


How do you remove a 1990 Beretta rear window?

rear side glass or rear windshield?


Where is the fuel pump in a 1990 4-cylinder Chevy beretta?

It is in the fule tank. you have to drop the gas tank to get to it.


Where is the starter on a 1990 Chevy Corvette?

Under the engine on the passenger side.


Need to replace starter for 1990 thunderbird super copue?

Remove - battery cable Raise and support vehicle Disconnect the wiring at the top of the starter Remove starter mounting bolts Remove starter