Twist filter counter-clockwise.
An ACDelco PF47 is an original equipment oil filter for that 04 Impala 3800 engine.
it is just above the oil filter remove oil filter and then remove the oil sending unit
the 3800 oil sending unit should be on the side of the block. It is screwed in right beside of the oil filter.
Remove the oil pan plug. Allow the motor oil to drain out. Replace the oil pan plug. Remove the oil filter, by turning it to the left. Fill the oil filter with oil. Put the new filter on by turning it to the right. Fill the engine was motor oil.
remove the oil cap on the top right of the engine. remove the oil plug from the oil pan underneath the car and drain the oil into container. Next remove the oil filter. The oil filter is on the left side if u are facing the car, covered by a plastic cover. Remove the oil filter and put a lining of oil on the gasket of the new filter. replace old filter and oil plug then put in 5 quarts of 5w30 motor oil. fin.
On the 3.6L engine it is on the top of the motor. You remove a access panel and unscrew the oil filter cup. The filter is a paper element under neath.On the 3.6L engine it is on the top of the motor. You remove a access panel and unscrew the oil filter cup. The filter is a paper element under neath.
right above the oil filter
On the front of the motor at the bottom just behind the front tire. The oil filter is inside the housing. There are three small nuts and one bolt to remove before you can get to the oil filter. On the front of the motor at the bottom just behind the front tire. The oil filter is inside the housing. There are three small nuts and one bolt to remove before you can get to the oil filter.
Place a drip pan below the oil pan and oil filter. Remove the oil pan plug. Drain the oil into the oil pan. Replace the plug to the oil pan. Turn the oil filter to the left, to remove. Fill the oil filter with oil and replace it to its original position. Fill the motor with oil.
4.5 quarts without oil filter change, 4.75 quarts with oil filter change.
3500 milliliters without change oil filter and 3800 milliliters with change oil filter
To remove the oil pan all you have to do is drain the oil and pull the oil pan bolts. Then you have to move it so you can get at the oil pickup tube bolts. You get those out then you can just let that fall down on top of the gasket which will then come off with oil pan. I had a hard time with this. I still had to remove the two bottom bolts, On the front motor mount and lift the motor 4-6 in.