0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you fix No camshaft signal detected during engine cranking on a 2000 dodge durango?
Replace the camshaft sensor
How do you replace a camshaft sensor in a 2002 3.3L dodge grand caravan?
how do you replace a cam shaft sensor in a 2002 3.3L dodge grand caravan
Why would there be oil in your camshaft sensor on a 1997 dodge neon?
Rear camshaft seal bad. Replace. located behind cam sensor.
Do you pull transmission to replace camshaft sensor on 2002 dodge ram 1500?
No, pulling the transmission is not required.
How do i install a 1997 dodge caravan 3.0 camshaft position sensor?
If I'm not mistaken, I think the camshaft position sensor on these engines is built into the distributor. You'd have to replace the whole thing.
Where is the camshaft sensor located on a 2006 dodge stratus?
Where is a camshaft position senser located on a 2006 Dodge durango/
Where is the camshaft position sensor located on a 2006 dodge stratus?
Where is a camshaft position senser located on a 2006 dodge durango/
Where is the camshaft sensor on a 2006 dodge ram 5.7 liter?
where is the camshaft sensor on a 2006 dodge ram 5.7 litre
How do you change the camshaft sensor on a 1997 Dodge Caravan 3.0L or is it better to just replace the distributor completely?
I think you will have to replace the assembly, Not sure if cam sensor is available seperatly.
Where is camshaft of 2005 dodge neon?
It's in the cylinder head... If you are going to replace it don't... If you had to ask that, you shouldn't be driving or even be near any car...
Where is the camshaft position sensor on a dodge ram 2500 5.7?
The camshaft position sensor on a Dodge Ram 2500 5.7 engine is located at the rear of the camshaft near the top of the motor. It monitors the motion of the camshaft and constantly updates the vehicle's computer.
How do you replace replace the camshaft position sensor?
In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.
