you take out the busted one and put a new one in Assuming its similar to a Durango here is how it is done: Answer That answer leaves a little to be desired. Actually, the cables for the power window run around inside the door on plastic guides and they sometimes break. I had to take mine to the dealer as they cannot be repaired and the power window system is one unit. Good luck! I've had three of these go bad on my 2001 Durango. Its never the motor and always the plastic guides or regulator as said above. I have found one dealer that did sell just the regulator without the motor but for most its all or nothing $300. If Dodge does it your looking at $600. They sell the entire regulator/motor assembly at discount auto $97.00 or pep boys $120.00 and the parts fit exactly. If you've never done this its probably best to go buy the part first so you can see what it looks like because you cant see it even with the door panel off. This will also give you an idea where the screws are for the old regulator/motor. Remove the door panel along with the white plastic sound proofing membrane if installed. Then you need to lower window down 3/4 of the way so you can remove the screws that hold the window to the mechanism. Then pull the window up by hand and secure up with block of wood in door or use a rubber door stop between window and door frame to keep in place. DO NOT LET WINDOW FALL. Then remove four screws that hold regulor guide in place, you will also need to remove 3 screws from motor. If the motor is riveted in place you will need to drill these out first ( replace with screws on reassembly that come with new mechanism). Disconnect electrical plug from motor and reach inside door panel and rotate entire assembly towards the back of the vehicle to get it out the tiny hole. It will fit through as assembled. Installation of new unit is basically the opposite except after you have the regulator and motor installed with screws, reconnect the electrical plug so you can lower the window clamp into position (about 3/4 down). Then remove wood or stopper from window and lower by hand into positon of the regulator clamp. Secure with two screws and your done. Takes less than an hour. == == Try this link. Hopefully it helps. http://www.dodgeforum.com/m_650637/tm.htm
Dodge Regulator Repair
98-04 Durango, Dakota. $90 W/ instructions. Fast Shipping
www.upanddownmainstreet.com
remove door panel, roll down window 1/3, unbolt from track
replace 1987 dodge pickup/power window motor
yes
they make a Dodge Dakota, witch is a very small pickup and a Dodge Ram that is a little bigger than the Dakota and you can get in flatbed and dually, witch you cannot get with a Dakota
No
i didnt know dodge made Dakota quad cabs in 89
go to walmart and pickup the aftermarket stereo installation kit for your vehicle. instructions included.
youll most likely have to buy the whole hub assembly. I had to do that to my 94 dodge dakota.
No.
Yes it does.
The Dodge Dakota pickup truck has CV joints on both front wheels. The pickup truck also has a driveshaft, as it is rear wheel drive.
It varies with what part of the country you live in. Call a couple of local garages for estimates
On Dodge Dakota it is integral to the fuel pump module and located inside the fuel tank. The filter itself is not serviceable or replaceable. To replace the filter, you must replace the entire fuel pump.