answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2012-07-22 04:52:23

If you have Live Lite / Launchpad edition etc. you need to go to preeerfnces and check you are sending midi from the launchpad as a controller. Then you just go into midi map and select your range for the Grid. You then do the same range for volume if you want a steady volume, but invert the range.THUMB IT UP SO EVERYONE SEES AND STOPS ASKING QUESTIONS

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still Have Questions?

Related Questions

What kind of brakes are on front of 1988 Ford Ranger pickup truck?

fordparts.com shows disc brakes on the front of a 1988 Ford Ranger


Where is the neutral safety switch on a 1988 dodge truck?

Drivers side, side of trans just below skift linkage.just unplug,screw out old and replace.


How much horsepower does a 1988 dodge truck 360 have?

245 hp


Will wrong timing of 1988 dodge truck stop truck from starting?

it could, all depends how off it is.


Does 1988 Dodge truck have a distributor cap?

If its a gas engine yes, if its a diesel no.


Timing on a 89 dodge truck?

The timing on a 1989 Dodge truck should be set to 10* after unplugging the temperature sensor.


How do you replace 1988 Chrysler LeBaron brakes?

Front or rear.. disc or drum type..??????????


Why 1988 Dodge truck stopped running has new battery?

bad alternator ? its not charging the battery


How do you check fuel lines for pin holes in a 1988 Dodge Dakota Sport truck?

don't know


Where is the fuel filter 1988 Dodge 150 truck?

inside frame rail under driver door


When On a 1988 dodge pick up truck is there a bolt on the face part of the power steering pump?

Only for mounting


How do you change fuel pump on a 1988 dodge ram 150 pick up truck?

Drop the fuel tank


Why is it hard to stop in a 1988 silverado you change the brakes and bleed them?

you change the brakes,check brakes fluid,bleed the brakes why is hard to stop in a 1988 sliverado?


How do you replace the fan belt on a 1988 ford mustang GT?

Drivers side of the frame under the truck


How big is a 1988 dodge ram truck gas tank?

32 Gallons on a long bed extra cab with 5.9l


Where is the egr valve located on a 1988 dodge d100?

Facing the front of the truck, it is located on the intake manifold on the right side of the carb.


How do you replace the rear drum brakes on a 1988 Chevrolet Celebrity sedan?

I would suggest you look in either a Chilton or Haynes manual for the proper steps to take to replace your car's rear brakes. There you will find instructions as well as illustrations that will help to get a proper job.


1988 Dodge Dakota Fuel Pump relay Location?

The fuel pump relay on a 1988 Dodge Dakota truck is located in the engine compartment, near the fire wall. It is contained in a water tight box which houses a number of relays and fuses.


How do you reduce Steering play in 1988 dodge w100?

replace worn steering parts rebuild steering shaft


How do you replace thermostat on 1988 Ford F-350 Diesel?

Is it easy to replace the thermostat on my Ford 1988 F-350 Diesel truck? My engine overheats when on long drives or steep grades. HELP ASAP. Bradley


How do you repair the brakes in a 1988 GMC Jimmy?

I have replaced the entire brake system in a 1988 gmc jimmy and still have no brakes can you help/


How do you change the heater core in a 1988 Dodge Ram 4x4 W100 truck?

Drain the water from your Dodge Ram truck cooling system. Remove the water lines from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.


How do you reset the ECU on a 1988 Dodge Dakota?

Disconnect the battery, then step on the brakes several times to help discharge any residual votage. Leave the battery disconnected for about an hour.


What does it cost to replace brakes on 1988 Mercury Sable?

Which brakes are you replacing front or rear or all four It shouldn't cost more than $100 with out parts and labor Or you can do them your self it's not that hard at all unless your are doing the rear brakes which will require a special brake spring tool


Where does the rotor point to when it's top dead center on 1 cyl 318 Dodge truck 1988?

on top dead rotor should be pointing at #1