0
First you pop the bottom of the door panel out. The next step is to take the three speaker bolts out ( 10 millimeters) After you remove the two nuts and one bolt holding the check in place you slide the door check inside the door and take it out through the speaker hole. Reverse procedure for installation.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you reset the check engine light on a 1999 Toyota Sienna?
Remove the battery head(+v) for a while, then replace it and star the engine.
How do you replace the rear door handle on a 1999 Toyota Sienna minivan?
check out this website it tells you how to repair the handle since it cost about $65.00 to buy a new one. http://www.findonefindall.com/toyota-sienna/
What does it cost to replace a catalytic converter on a 1999 Toyota Sienna?
How much does it cost to replace the catalytic converter on a 1999 Toyota Tacoma
When replace timing belt Toyota Sienna 1999?
Replace it every 90,000 miles. Warning: This is an interference engine. If the belt breaks serious engine damage will occur.Not true, 1999 Sienna DOES NOT have an interference engine
1999 Toyota Sienna turn signals quit working?
Check fuse or turn signal flasher
Do auto body shops have to replace the bumper protector to replace the bumper cover on a 1999 Sienna?
if the bumper protector is damaged yes, or else the cover will have no suppot
How do you replace driver side seatbelt buckle 1999 Mercury Marquis?
You have to replace the entire assembly.
AC light blinking 1999 sienna?
what cause the ac light to blink on a 1999 Toyota sienna
Does the 1999 Toyota Sienna have an Interference Engine?
no. if the belt breaks just replace it making sure the cam timing is properly set
How do you replace driver side Mirror motor on 1999 bravada?
you can not pea brain
How do you replace the rear wheel bearing on a 1999 Sienna?
I assume that it will be like a 1998 Sienna van. There is a sealed bearing in the hub assembly and you change the whole assembly. There are four bolts that hold the hub assembly to the suspension.
How do you replace a rear wheel bearing on a 1999 Sienna?
I assume that it will be like a 1998 Sienna van. There is a sealed bearing in the hub assembly and you change the whole assembly. There are four bolts that hold the hub assembly to the suspension.
