OK, here is a better understanding of how a immobilizer works; each key has a code imprinted on it, no battery of any type just a random code. When you go to start the car the immobilizer computer sends a signal to the key. If the signal it receives back from the key matches one of the 5 keys it keeps in its memory, it sends a "OK start" message to the PCM starting the car. If it doesn't see the "OK start" signal it doesn't start and the green key light in the dash flashes. In short there is no way to reset it. Try another key. If not, there is a way to bypass it shortly to get the car to a Honda dealership for reprogramming of a key or key replacement. Your Prelude may also have a problem with one of these components. It will need to be hooked up to a Honda scan tool and checked for immobilizer codes.Let me know if you have any questions. I'm a 6 year factory Honda tec. I will try and answer all I can.Here is how to use the "pcm brake code" You weill need to call your local dealership and give them you vin # to get the code.To start the engine, follow this procedure:1. Cut a temporary key using the key code and anon-transponder key blank.2. Turn the ignition switch ON (II) with thetemporary key.3. Enter the first digit of the immobilizer brake codeby pressing and releasing the e-brake pedal the samenumber of times as the digit. For example, if thefirst digit is 4, press and release the e-brake pedal 4 times.4. Turn the ignition switch to Lock (0) and then backON (II).5. Repeat steps 3 and 4 to enter the second, third,fourth, and fifth digits of the code. You have up to30 seconds to enter each digit.6. After you enter the fifth digit, the immobilizerindicator on the dash will blink five times,meaning you can now start the engine with thetemporary key.While the engine is running, the immobilizerindicator will stay on. If the engine isn’t startedwithin 10 minutes, you’ll have to reenter theimmobilizer brake code. You’ll also have to reenterthe code if the engine is shut off for more than 10minutes.This also workes for any Honda immobilizer system. However you need to use the brake pedal. Only preludes you used the e-brake.
Power the radio, and then enter the anti-theft code using the preset numbers at the bottom of the radio. If the anti-theft code is unknown, contact Honda with the 17-digit vehicle identification number.
how
You insert the code with the radio presets. Just push the reset # that corresponds to the radio preset. If you have locked the radio up just leave it on for a few hours and it will reset so you can enter the code again.
You should have gotten a card that has the anti-theft code when you bought the car. If you dont have the code then you'll have to go to your dealer to have them reset it or provide you the code.
The only way to reset the code on a 2004 Nissan Maxima's anti theft system is by taking it to the dealership.
The key is faulty or the immobilizer will not accept the code. remove the battery for 30 mins to allow the system to reset.
Unhook battery cables to reset and then when you turn radio on again just type the code using the numbers 1-6
use a code reader , or take off the negative battery cable off for a few seconds & don't for get to have the radio theft code handy.. after taking off the cable hondas theft system will disable the radio .
You must go to your Honda dealership. This code is a security code you are not able to receive this code online. Also when going to the Honda dealership bring ID and proof of Ownership to receive code.
The code varies from car to car. You will need to contact the local Honda dealership to see if they can provide you the code to reset the Pilot's radio.
how do you reset anti theft on a 1994 toyota camry
You have to go to a Honda dealer and they will give you the code.