It's incorporated in the turn signal stalk.
It's what you use to signal to go left or right.
You punch in the alarm code on the drivers side door. If you don't know it, there is a decal on the right side trunk hinge with the code...
Open the door and it will turn off
What is the answer?
On a 1996 Camry. you just gotta turn your car off, than open the door then the alarm will sound, after you close the door, turn the car on (not the engine), and then turn the switch to off, it is located by the handle to open the roof. Then alarm should turn off.
You reset the factory alarm by unlocking the doors with a key or remote.
Key in driver's side, pass side, or trunk - turn to "unlock" position - stops the alarm
You have to use a 1/2 inch breaker bar and put it in the square hole of the tensioner and turn it to release the tension of the belt.
You put the key in the driver door and turn to the unlock position.
put your key in the door and turn it. Please Rate!!
There is not a flasher on a 1996 Lincoln Town Car. The turn signal and hazard flashers are operated by what is referred to as the lighting control module. It is located in the dash behind the knee bolster above the accelerator pedal.