doesnt matter they work in either you are ok just dont doit unless emergency
Change oil and filter
go and hve the power steering system flushed
Do not pump the brakes. You will need to get all of the contaminated fluid out and refill the master cylinder.
did u put a little bit or alot? if its a little use a turkey baster to suck it out
You need to remove the washer fluid. You can siphon it out, or remove the power steering reservoir and dump it out. If you haven't had the car running , you may be able to absorb it out with a rag since it is probably floating on top of the power steering fluid. The problem with washer fluid is that it is not compressible and will cause poor steering reaction when it enters the steering pump. It may even cause a loss of steering.
The first thing you should do is remove the master cylinder so you can dump the brake fluid reservoir out. If you have used the brakes, it is a very good idea to get the entire brake system bled and replace all the brake fluid.
Take off the reservoir & flush it out with hot water to get the oil out. If you drive it it can go through the cooling system and it may distort rubber seals etc. If it's a very minor amount it might not be an issue but flush it to be safe.
the filter is built into the power steering reservoir . the filter cant be replaced separately . the reservoir itself should be replaced.
When you open your hood there should be a container on the left with a black cap. That is your power steering reservoir. When you open your hood there should be a container on the left with a black cap. That is your power steering reservoir.
yes should be a reservoir cap on top of steering pump
go to a mechanic immediately
The 1997 Jaguar power steering fluid reservoir is located on the back of the engine near the firewall. The top on the reservoir should be labeled as power steering fluid only.