I also have the same problem , am interested in what info. you come up with please,hit me up at hock@Yahoo.com
There will be a pin on the front bottom of the cylinder housing. Turn the key to the on position then push the pin in and pull the cylinder out.
Position Ignition was created in 2009.
There is a short somewhere in the ignition system causing the fuse to burn out. Start by replacing the ignition switch to see if that helps.
When the key is in the "start" position all accesssories are designed to be "locked out" to concentrate all the available power to the starting circuit. How about the "on" position - do accessories have power at that position? - if not could be a bad ignition switch
This may sound ridiculous... but force the the ignition switch until the detent "breaks" and you can turn the ignition switch without the key. The risk here is that you could possibly break the assembly that the ignition switch inserts into. If you can get the switch to rotate from the lock position one position clockwise, then you can release the switch from underneath the steering column and pull the switch out. The alternative is to have a locksmith get the ignition switch to rotate one position clockwise and then you can remove the switch and replace it with a new one from any auto parts store.
Check for loose connection of positive cable at battery, crankshaft position sensor faulty, or ignition module faulty.
Yes, the ignition switch must be in the ignition position -not- the accessory position.
what is the wiring position for the ignition module on a 1990 Buick Park Avenue?
the crank shaft position sensor should be behind A/C compressor.
The 2.2L Ecotech engine does not have a Camshaft Position Sensor. It has a unique type of ignition system which consist of Ignition Module, Ignition Coil Assembly, and a Crank Sensor.
you dont! it has to be in the off position
you need to be more specific. i am going to assume you want to know in what position is the ignition switch in lock. usually it is 2 positions back from "run" but it is in whichever position the key comes out of the ignition.