Installed incorrectly, driver who rides the clutch, clutch out of adjustment, weak pressure plate, that should have been replaced along with the clutch.
take the battery out of it then power on again
the cold breeze starts at land, when it is at sea it becomes warm. Then it blows back to land where it becomes cold again
its probable that the clutch is going and the reason why it works after you start the car back up is your giving the clutch a chance to cool "if even for a second" and the fingers on the pressure plate extend back out enough to do you some good....look into having it replaced.
the sprag clutch ( overrun gear ) is gone and needs to be replaced a new part can be bought but normally the complete starter is changed in some cases squirting diesel oil on the sprag clutch can cure the problem but it normally reoccurs again
It is a hydraulic clutch. No adjustment. Can bleed air out of the system to get it working again. If you need info on that I will supply it as soon as you ask again that you want to know how to bleed the clutch on an escort zx2
94 the year of Ford auto clutch. It has allways been a problem. Plastic parts fluid leaks.
True. Renewable resources can be replaced or grown again.
No. You will stall(or cut-out). This means that the car shuts down and then you have to clutch in and put it into neutral. Then(still on the clutch) turn on the car again.
yas he did get replaced but came back again
you need to check and make sure you are getting a full 12 volts across the clutch coil (while connected to the clutch) you may have a bad contact somewhere and if you are only getting like 8 volts the clutch will burn out at a high rate because it is not fully engaged. make you check the voltage while under a load!!!!
The torque converter clutch is probably sticking. The clutch is controlled by a solenoid, that moves it back and fourth. The clutch material can get stuck to the inside of the converter and stall the engine. This problem can be worsened by heat. Have the transmission flushed, and if the problem persists, then have the solenoid replaced.