0
If my truck won't go how do i tell if it is the clutch gone out or the manual transmission?
Wiki User
∙ 16y ago
First off can you feel it shift through all the gears while off (not running). Second off while running can you shift through the gears or does it grind while trying to shift through them. If it grinds when you try to shift then your clutch is shot. Good luck
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Why is 5th gear and reverse gear gone on your 5-speed manual transmission in a 1996nissan pick-up?
if you are missing any gears in your manual transmission it is shot. You might as well replace the clutch while you have the tranny pulled so you dont have to do it later.
How much does it cost to replace a manual transmission in a 1999 ford escort LX?
About $2000 if you have a rebuilt put in. More if you have a new one put in. You can get a used one from the boneyard (salvage) for about $550 and it is about $500 labor to get it put in. If you are having problems with the manual transmission, take it to a shop to make sure it's not the clutch that has gone out. It won't be any more or less labor, though, because the transmission has to come out to replace the clutch.
How do you know when the clutch master cylinder is gone in a 1995 escort?
Whenever you are having a problem with the clutch disengaging the engine from the transmission it is advisable to bleed the clutch slave cylinder. If the clutch can't be operated by bleeding the slave cylinder then the clutch master cylinder is gone and should be replaced.
Are all forklifts equipped with a clutch?
No. In fact, having a clutch is not the norm for most forklifts in current productions, as manual transmissions for them have mostly gone out of vogue.
Why wouldn't a transmission go into reverse but goes into drive just fine?
It means the reverse clutch pack has gone out in your transmission and needs to be rebuilt or replaced.
What's wrong when your clutch goes in but can't shift?
well could be throw out bearing gone,cable broke,probably worn out clutch.Check to see if clutch has oil resv. for manual clutch,slight possibility it is out of fluid if never been topped up.
How do you tell if the clutch master cylinder is gone out on a 87 king-cab Nissan truck?
first check your clutch slave cylinder for leaks, if its leaking ,replace and bleed system,if its not leaking,bleed system ,dont forget to bleed clutch damperand if its still not right, then replace clutch master cylinder.
Mazda 1987 truck will not shift into any gear but reverse?
Well you have a strange issue. Being the trans will not shift into any but reverse would point to the clutch being toast. Normally if the truck will not shift is the slave clyinder or even the clutch master or throw out bearing gone. To rule out the the throw out did it noise while the truck was in neutral and even while in gear.If either apply may be the throw out is gone, but sounds 100% clutch is gone. If the truck will shift into soley reverse then this would rule out the slave, and clutch master cyldr and even the throw out in most cases due to the it is moving the fork to engage the clutch and the surface of the clutch is worn to it's life except reverse due to it is not used as much. I recommend a new clutch and replace the throw out bearing and would be a good idea to replace the pilot bearing and go ahead and do the rear main seal even if its not leaking if its got lots of miles, plus the age would make me do it being you have the trans pulled out.
The car will only go in reverse and will not drive forward What do you think it is?
truck will only go forward not in reverse does this mean the transmission is gone
Rover mg zt clutch pedal gone to the floor?
The clutch cable has proabably broken.
How do you know your clutch has gone?
Slipping, chattering, or grabbing.
Why won't a 2.2 run any faster than 30 mph?
Hmmm.... You have some sort of very serious problem. Does the car idle normally? Can you rev it up with it out of gear and do the RPM's come up normally? You should be able to rev it to 3000 or better easily. Is there any trace of coolant in the oil? (indicating a blown head gasket) If you can rev it up normally, but when in gear the car achieves barely 30 MPH, I'd suspect something in the transmission has gone bad. Or, if you have a manual transmission, you may have a bad clutch. If it's a manual, you should be able to put the car in 2nd gear, slowly let the clutch out and make the drive train kill the engine. If you can't kill the engine by letting the clutch out, your clutch has died. See if you can give us a little more info to work with, OK? FriPilot
