If the heater died in a 1993 Oldsmobile Cutlass Supreme would it be a fuse?
Yes, if the blower isn't working. If it turns out to be the fuse, and it blows again, you probably have a bad blower motor.
It seems that they most problems with the 93' Oldsmobile cutlass supreme would be the engine and the break. Those seem to go out the most on this car. Read More
The master cylinder contains the reservoir for the brake fluid. This is where you would add it on an 1990 Cutlass Supreme. Read More
What would be the problem on a 1996 Oldsmobile cutlass supreme that all the power windows are not working?
Blown fuse? Read More
At the firewall on the passenger side Read More
Try changing the fuel filter and the map sensor. Read More
Throttle plate stuck in open position Read More
sad to say.but i do not know either... i have a 1994 cutlass supreme sl and am looking for the same answer. if you hapen to find the answer. i would appreciate it if you would contact me at email@example.com thanks Read More
more than likely you have a blown fuse in the fusebox for the power windows. Read More
Why would the blower not work on a 1989 Oldsmobile Cutlass Sierra windshield when the car is running yet work when the car is set to AC?
Might be a bad heater control Read More
What would make a 1899 oldsmobile cutlass ciera start and then die right away? Read More
Perform throttle body sevice Perform idle /air control motor service,replacement Read More
You Don`t Need The Special Ones On This Car. Just Use The Green Color Regular One. Read More
With the key, there is no trunk release inside the car. You use the same key you would use to open the door to open the trunk. Read More
Because its a POS.. j/k could be a bad fuse/relay or the motor is bad. but serious its a POS.. Read More
There is a fuel cut-off switch under the hood that needs to be reset. Should be on the left side near the back. Read More
Can you put a 1967 Buick skylark 350 motor and transmission into a 1971 Oldsmobile cutlass supreme that had a 350 rocket in it before if so what would you have to change?
In 67 Buick didn't have a 350. It would have been a 340 or a 300 possibly a 400. Read More
1992 olds cutlass supremes do not have MAF sensors. the 3100's had them, and there were a few of them in the early years that didn't have them as well. the only sensor you will have before your throttle body would be the IAT sensor in the air filter box or plumbing..... Read More
Do you need to know what the torque would be to find out if the idler tension pulley has to be torqued when you install the serpentine belt on a 1995 Oldsmobile Cutlass Supreme?
there is not a specific torque for the idler pully. tighten it up with a ratchet and it will not loosen up Read More
What would cause a terrible grinding noise from the front wheel drive on a 1995 Oldsmobile Cutlass Supreme?
It could be a few things hub bearings, brakes, ball joints or possibly the CV axle. I would have it checked and then fix the problem at home if it is within your ability. Read More
Probably because you need to check the engine. Read More
It is incorperated with the PRNDL switch on the trans. Read More
you would use 5W-30W have the same car Read More
cracked or broken wiring, blown fuse Read More
the best way would be to locate the horn and disconnect (pull) one of the wires off of it. your horn fuse may work with other electrical items, so its best to disconnect from horn itself. hope this helps! Read More
Sometimes the Cutlass sedan and the Delta 88 would share the same wheel design. Read More
The emissions decal on the fan shroud will have a crude diagram telling you what goes to what. Also, a chassis manual(factory service manual) would have it, and possably a chiltons book. -Martin Deutschman Stop by www.oldspower.com they can help you out. Read More
92 olds cutlass supreme convertible has water on drivers side floor board--does not smell like antifreeze from the heater core any idea what else would cause this?
windshield leak that runs down behind the dash and onto the floor. Read More
Hose leaking Water pump leaking Read More
If there are no visible leaks....a blown head gasket. Read More
What if the Rotor does not easily come off of a 1988 Oldsmobile Cutlass Supreme what other methods are there to remove it?
Once the caliper is off then the rotor should come off. If not take a hammer and beat on the rotor. Then it will either come off or crack and come off. If that does not get it off you would have to heat it with a torch. Read More
The cost of the head gasket itself would be anywhere from approximately $20 - $40 per piece (there are two head gaskets, as 1995 Olds Cutlass Supreme has a V6 engine) depending on whether you have the 3.1L or 3.4L DOHC engine. Most of the cost will go to labor; it is a time-consuming job. Best to call a few shops to compare and get estimates on actual labor and parts prices. If anyone has… Read More
Replace ignition module (under the distributor cap) Read More
you have to be more specific for a proper answer... at what speed does it shake?.... 40mph> ? what do you mean mist? Read More
83 cutlass is either in the steering column (down low away from the turn signal probably, or in the column "multifunction switch", possibly on the floor, but one would assuem you have looked. Relentless Read More
Either the chip in your key is worn or the contacts in the key cylinder are bad. Read More
.980 machine top discard would be .965 there now. Read More
That car would have a 19 gallon fuel tank. Read More
'would the bolt pattern for rims on an 1986 cutlass supreme be the same as on a 1992-'97 front wheel drive cutlass?
No there rear wheel drive rims are different than front drive rims Read More
if it smells like antifreeze inside the cockpit then your problem is the heatercore, since you can't see it. Read More
1-Cold weather - normal operation. 2-Computer reset, especially after battery replacement. 3-Low coolant (antifreeze) level. 4-Stuck IAC. 5-Air conditioner turned on. Defroster included. Read More
The "mass air flow" sensor would be located in the snorkel between the air filter box and the throttle body. Read More
Why would you have no brake pressure after replacing brakes rotors calipers and after bleeding the brakes on a 1991 cutlass supreme?
Bleed the master cylinder.& then rebleed the system. Read More
If I have a 1996 cutlass supreme What would cause my turn signals not to work if the Fuse is fine and the 4 ways work?
You have a bad turn signal flasher. Read More
20's-24 that should do it i have 23's on mine after i got it lifted Read More
Autozone carries this type of sensor, runs around $15 Answer It is located behind the engine near the firewall. It's a bit tricky to get to it, you would need to rotate the engine forward. Then look under the exhaust manifold under the cylider closest to the drivers side. 10 mm deepsocket for the bolt. That's fine but I want to where it is on a 1996 Olds. Cutlass supreme. Read More
It doesn't have one. A pickup coil would be found in a distributer, and that car does not use a distributer. There is crankshaft position sensor located on the front of the timing cover, and there may or may not be a cam position sensor, located under the water pump area depending on whether it is a Delco system or a Magnavox system. Read More