0
If you replace the resistor on the blower motor on 96 Jeep Grand Cherokee but still get only high speed or nothing from blower is there another possible cause?
Wiki User
∙ 16y ago
If the fan runs only on high then it is probably the blower motor resistor, and not the blower motor itself. This is pretty standard in any vehicle. It should be located somewhere near the blower motor. --------------------------------------------
There are two circuits that power the blower motor. A relay switches between the two different circuits. The high speed circuit suplies battery voltage to the blower. when you set the blower speed switch to any other speed but high the current passes through the other circuit. The blower resistor is in this other circuit. Check the fuse that supplies power to this circuit, check the relay that switches back and forth between the two circuits. Check the switch. Check the wiring. A VOM (volt/ohm meter) is very useful for this type of trouble shooting.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you replace the fan switch on dashboard of 2002 Jeep Cherokee. Only turns on full blast -4 or nothing?
I would suspect you fan switch is not the problem but it is possible. Normally this is caused by a defective blower motor resistor pack. Inspect that before replacing the fan switch.
Ism there 0 ohm resister available in market then its colour coding what?
Why would you buy something that does absolutely nothing? If you need a "zero ohm resistor", just don't connect any resistor at all.Why would you buy something that does absolutely nothing? If you need a "zero ohm resistor", just don't connect any resistor at all.Why would you buy something that does absolutely nothing? If you need a "zero ohm resistor", just don't connect any resistor at all.Why would you buy something that does absolutely nothing? If you need a "zero ohm resistor", just don't connect any resistor at all.
Is it possible to say that one type of war is worse than another?
No nothing is impossible
What does Darin mean in Cherokee?
Nothing. Cherokee doesn't have an r so there can be no word with an r in it like Darin.
What did the Cherokee children wear to bed?
Nothing, they did not have clothes.
What happens to the resistor when there are more components?
Nothing happens to the resistor other than it may interact with the other components so as to perform a desired function.
What is the voltage drop across a 12 ohm resistor with a source of 24 volts?
If there's nothing else between the ends of the resistor and the power supply, then the voltage across the resistor is 24 volts, and the current through it is 2 amperes.
Why did Western democracies do nothing to stop Hitler in the 1930s while it was still possible?
They were scared of starting another war
You changed the blower resistor on your 2003 dodge durango and the new part looks nothing like the old one Is this normal?
It is common for blower resistors to supersede to new style parts.
What is the volt drop across a 10k resistor with a 5 volt supply?
If there is nothing else in the circuit, then the voltage drop across the resistor will be the full supply voltage of 5 volts. The size of the resistor does not matter in this case - it will always be 5 volts.
What happen to the voltage across each resistor when all of the resistors are doubled?
Nothing. But the current is halved.
Why are fixed resisters used in many circuts?
Hi, where there is no need of changing the value of resistor then why do you place variable resistor instead a fixed resistor. After all the selection of resistor depends on the cause of use in application. by the way wide range of resistor values are avilable in the market. if the application requires tuning operation then variable resistor is need to be mounted. nothing is mandatory unless the application requires. Regards, Manjunath A.V
