answersLogoWhite

0


Best Answer

I believe there are four screws. Two under the two air vents in the dash and two up in the cubby hold under the cig lighter and ashtray

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: In a 93 Nissan Sentra how do you remove the middle panel containing the radio?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove the distributor cap and rotor on a 1994 Nissan Sentra?

how do you remove a distributor rotor on a 92 Nissan sentra


How do you remove a speed sensor on a 2008 Nissan sentra?

nissan sentra 2008 std


How do you remove Nissan Sentra headlight housing?

go to the dealer to do this


How do you remove a 1998 Nissan Sentra transmission?

To remove a 1998 Nissan Sentra Transmission, you first need to locate all of the bolts. From there, you will remove the bolts. Undo any wiring or tubing that goes into the transmission. From there, it can be taken out.


How do you remove brake drums on a 1989 Nissan sentra?

very carefully :)


How do you remove the front door panel for a 2001 Nissan sentra?

How do you remove and install front door panel 1985 Nissan Sunny


How do you remove the starter from 2001 Nissan Sentra SE 2.0 liter engine?

can a starter be removed from the top on a 98 Nissan sentra gxe


What size wrench to remove caliper from Nissan Sentra?

10mm or 3/8


How do you replace door hinge bushings on a 1993 Nissan Sentra?

Have to remove the door, then remove pins and bushings


How to remove the door panel on a 1989 Nissan Sentra?

take it to a strret raceing shop!


How do you remove a driver side mirror off a 1997 Nissan Sentra?

To remove the mirrors from you Nissan Sentra first remove the inside door panel. Pry the plastic mirror cover off of the mirror. Once this is done remove all of the nuts, bolts, or clips holding the mirror to the door.


How do you remove the rear bumper on a 2004 Nissan Sentra?

To remove the rear bumper on the 2005 Nissan Sentra, you will first need to remove the rear bumper cover by using a flat tool to pry the pins. Then, access the bolts holding the bumper to the frame of the vehicle and remove the nuts. The bumper will then lift off.