answersLogoWhite
Auto Parts and Repairs
Alternators
1995-1999 Dodge & Plymouth Neons
Pontiac Grand Am

Install alternator on 1989 Mazda 929?

Be the first to answer!

123

Related Questions


WHATS THE TIMING MARKS ON 93 MAZDA 929


I have a Mazda 929 (1993) I had the same problem last year...I got a new alternator, and some new wires and spark plugs. Haven't had a problem with it since.


What is a timing cover seal on a 1992 mazda 929 and where is it located at?


929 1990 Mazda power brakes fails


you have to remove the dash and every thing attached to it. Is it the same for a 1988 Mazda 929?


originalkeyless.com they have the remote and the programming for Mazda 929's


In Canada traction control was optional on the 929.



WHERE IS THE FUSE BOX IN MY 929 MAZDA AND WHERE. HOW DOES THE ENGINE CHECK LIGHT LOOK AND LAST WHY IS IT ON AND STILL RUN


It is important to know as much as possible about the car that it is driven. Yes, there is a clutch adjustment on a 1991 Mazda 929.?æ


The 1994 Mazda 929 dryer receiver is located on the firewall in the engine compartment. The dryer receiver will be on the passenger side of the firewall.


the s is a higher horse engine by about 30 horse I believe


One can purchase a Mazda 929 from the Auto Trader website where there are many of these vehicles listed for sale. One can also get them from AOL Autos and eBay Motors.


The Thermostat is located at the low side radiator hole housing ( one end of the hole is connect from the radiator and the other end is connect to the housing


I have a 1989 929, when its cold it runs real bad but once warmed up it has problems idleing, the car shakes and sometimes when stopped it stalls, mine is an auto, but when driving like on the highway it runs fine. Is your problem similar?


In the engine bay. Infront of the stuts



i heard an 89 runs about 3500 pounds


trade it for an rx-7sit back and relaaax. 929's are for cruising :)


BECAUSE ITS DOING ITS JOB!!!!!!!!!!!!!.whats your next question. why does my Mazda have doors?



sounds like your distributer is getting moisture in it


Underneath each side of the exhaust manifolds.


well it's a very difficult job, so just take it to the dealer and $2,000 later you'll have it done! Don't forget to take a cup of coffee with you...............


Need to know the year and the size of motor



Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.