0
Is a 6 gauge 4 conductor wire still used to install a 240V 50A hot tub more than 50 ft away from the panel?
Wiki User
∙ 14y ago
Yes, that is the correct wire gauge. However, if your tub is much more than 100 ft. from the panel you might consider going up in wire size to #4 due to voltage drop.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Can you install a 150 amp meter base and still have a 100 amp main panel?
The wire size in a meter stack is governed by the size of the first over current device.
The pool panel says the salt cell needs to be serviced it has been cleaned and reset and it still is not working The panel says salt 0000?
The pool panel has to be repaired in order to indicate the correct level of salt.
Is a lamp contact a conductor or insulator?
The "contact" ... that is, the point where one side of the power circuit is connected ... must be a conductor. When the switch is 'open', then one contact is physically separated from the other one, and no current flows between them. But the contacts themselves are still conductors.
How far can you run a 12 gauge electrical wire?
This is a voltage drop question. To answer this question an amperage is needed.
Why switch is always connected in the phase wire?
First of all, the correct term is 'line' and not'phase' wire. The reason a switch is always placed in the line conductor, rather than in the neutral conductor, is that its function is not simply to break the circuit, but also to ensure that the circuit's load is disconnected from the line potential. If the switch were to be placed in the neutral conductor, it would still break the circuit, but the load will still be at line potential and present a shock hazard to anyone attempting to work on the load (e.g. to remove a lamp from its holder).
In what form should I purchase Category 5 cable?
I would recommend the solid conductor form because it is easier to plug in and install. They can be exposed to UV rays and still work.
Can a fuel pump still pump without the right pressure?
Yes it can and it can mislead you. Install a pressure gauge at the test port and get a reading. Check your shop manual for the required pressure.
Can you install a 150 amp meter base and still have a 100 amp main panel?
The wire size in a meter stack is governed by the size of the first over current device.
1988 VW Fox have changed high and low oil pressure senders and oil light still stays on what do you do next?
Install a manual gauge to actually read oil pressure
What is a Radiation conductor?
Vacuum is a good radiation conductor, and on a good day, the sunshine feels warm. Air is less good, but still a fair conductor.
Is snow a poor conductor or good conductor of heat?
i think it is poor but i thought again ithink it is good conductor . and btw i still don't know if snow is a good or poor conductor of heat lol
Is snow a good conductor or a poor conductor of heat?
i think it is poor but i thought again ithink it is good conductor . and btw i still don't know if snow is a good or poor conductor of heat lol
If a solar panel cracks does it still work?
If a solar panel cracks it may still work. If solar panels are cracked down the seam they should still work.
Where is the oil psi sending unit located on a 85 GMC 350 so that i may install a mechanical gauge?
At the top rear of the engine behind the distributor. You can purchase a tee fitting and still have to use of your light for a backup.
Will alternator still work if the gauge is not?
An alternator does not need a gauge to work. It is used to monitor the output of the alternator.
Do they still make revelation 12 gauge shotguns?
No.
Are 16 gauge shotguns still made?
One might recognize the two names Browning and Remington. They still make 16 gauge shotguns, as do a few other manufacturers.
