Spin the oil filter on until it stops against the flange. The tighten it 3/4 more of a turn - no more (visualize tightening it from 12:00 all the way around to 9:00 - 3/4 of a turn).
Coulpe of things to look for. Not tight enough, they say hand tight By I put an extra 1/2 turn after hand tight. Old rubber seal from old filter was left on block. cheap filter. You may of pinched it while tightening the filter (if you used a filter wrench as I do
Hand tight is usually all that is required. I recommend turning it 3/4 turn after making contact with the mounting surface. That way it is tight enough but not too tight.
No..maybe a oil filter wrench to remove it, but, install it by hand (HAND TIGHT)
any oil filter on any vechile should only be hand tight. be sure and check for leak's after installing oil.
there is no torque on the oil filter!! when putting back on tighten the filter hand tight as much as you can.
you only tighten it hand tight. but make sure you turn till it wont turn no more, just hand tight.
Most oil filters say to go one full turn after the rubber gasket makes contact. I usually tighten an oil filter hand tight. Use both hands and tighten it as much as you can get it. You don't need to use a filter wrench to get it tight enough to seal. Run the vehicle and check for any leaks. That's it.
There is probably no spec-they are supposed to be hand tight only.
Neither your oil filter, or the fill cap need to be loose, the filter should be screwed on as tight as you can get it by hand only, and the fill cap should fit snugly so it does not come off. If the oil filter is loose or too tight you can blow out the seal which will cause you lose all your oil.
Turn the filter buy hand, then one quarter turn with the oil filter wrench. That's plenty. Make sure you put some new oil on the rubber gasket with your finger before screwing it on.
Take it off during a oil change. Righty tighty, lefty loosy. Put it on hand tight, hard.
Take the filter off and look where it mounts onto the motor to make sure there is not an old gasket stuck to it and if there is take it off and then put on a new oil filter hand tight, be sure to put oil around the gasket on the new filter before you install it.