answersLogoWhite

0


Best Answer

IF YOU LOOK AT THE DOOR WHERE THE THREE SCREWS ARE, IS EVERYTHING STRAIGHT OR IS THE LATCH IN SLIGHTLY? (1/16" WILL MATTER) IF YOU GET IT OUT WHERE IT NEEDS TO BE IT SHOULD CLOSE AND LATCH. (WHEN IT IS IN TOO FAR THE LATCH HITS THE LOOP AND THE DOOR WON'T CLOSE) ALSO CHECK TO SEE IF THE SHEET METAL HAS CRACKED BY THE HINGE, CHECK THE LOWER ONE, THIS WILL NEED TO BE WELDED.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is it difficult to replace a passenger side latch on a door the latch has come undone and the door will not close and latch right does anyone have a solution the three screws have been replaced thank?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the heater core located on a 1993 Toyota Camry and how difficult is it to replace it?

Passenger side, near the firewall. It is not difficult to replace, it is just very difficult to get to.


How difficult is it to replace the heater core on a 1994 Ford E150 van?

Fairly difficult. They are easily replaced, but hard to get too.


Where is the blower motor in a 1995 Tahoe and is it easily replaced?

it is located under the dash on the passenger side. it is large and round, covered in insulation-backed rubber. it is not super difficult to remove and replace, but it does require some body contortion on your part.


How can a cracked screen be replaced on an iPod Nano 4GB?

If your iPod Nano visibly cracked, Apple will replace it with a cost. If you prefer to replace it yourself, it is entirely possible, but it is recommended to have it replace by the professional, since it is quite difficult.


What is the past tense of replace?

The past tense of "replace" is "replaced."


The dust boot seal on the rear caliper is broken on my 2001 Passat. What can happen if I don't replace it Can it be replaced How difficult it is?

The brake caliper boot seal keeps out dust and dirt. If not replaced it can cause the caliper seal to leak and the brakes to possibly fail. It is simple to replace.


The front passenger and rear driver passenger power window stoped workingI check all the fuses and they are working. the rest of the window work perfect what would be the solution to this problem?

I would replace the master window switch


Why don't a rear passenger window work after its regulator has been replace?

If it worked before the regulator was replaced, something was done incorrectly. If it didn't work before the regulator was replaced, the electric motor, switch or wiring may be at fault.


How do you replace the clio front passenger seat tilt cable?

How do you replace the clio front passenger seat cable


Have often should you replace a timing belt in a 98 Chevy Prizm?

The Prizm has a timing CHAIN, not belt. The timing chain does not get replaced on a scheduled interval. It should never need to be replaced. The serpentine belt, however, does need to be replaced. Inspect the belt for cracks and glazing, and replace. It is not a difficult DIY job. It is easiest to do it from under the car, after removing the splash pan.


Where is the water pump located on a 1992 Pontiac Grand am SE and how hard is it to relplace?

The water pump is located on the passenger's side of the vehicle near where the engine belt is located (on a 3.3L engine). It seems to be a little difficult to get to. Have always had someone else replace my water pump don't know how difficult it is to replace.


How difficult is it to replace the crankshaft sensor in 02 Chevy Avalanche?

I have a 2002 Avalanche abd replaced it last year---8.1 liter-----it took my mechanic about 3 hours to get it out/in.