yes, they will get hot any time that the key is on
The ignition coil is inside the ignition distributor.
You can test the ignition coil on a car by using a multimeter. A bad ignition coil can be the cause of a car not starting.
No. The coil provides the spark and the module tells the coil when to spark.
Remove the wiring harness from your 1999 Mercury Grand Marquis ignition coil. Remove the ignition coil retaining screws. Reverse the process to install your new ignition coil.
The 1998 Toyota ignition coil is located on the firewall, in the engine compartment. The ignition coil can be found on the passenger side of the firewall.
where is the ignition coil on olds 2.3liter 89 cutless vin d
The ignition coil that is suitable for the hall sensor ignition must have a yellow label.
Its right above the ignition coil. Infact you have to remove it first to remove the ignition coil.
Where all the wires plug into. That is the ignition coil. The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
V6 Engines * Disconnect the negative battery cable * Disconnect the electrical connector from the ignition coil * Disconnect the spark plug wires from the ignition coil * Remove the ignition coil mounting bolts and remove the coil from the valve cover V8 Engines * Disconnect the negative battery cable * Disconnect the electrical connector from the ignition coil if youre going to remove more then one ignition coil mark each electrical connector with its corresponding coil to prevent mix-ups during reassembly * Remove the ignition coil hold-down bolt * Grasp the ignition coil firmly and pull it straight up
REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.
did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity. did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity.