it will run, but the removal of exhaust components can result in a decrease in the system back pressure. That can cause a problem with proformance, and may lead to problems with the motor. It is a matter of making sure the amount of air going into the motor and out are right. If you are going to take it off, check to see if the air in is okay to the air out. it probably won't cause a problem, but thought you know that they can happen. hope it helps. duboff
Have you changed the main jet? Sounds like needle not seating fully or correctly.
to keep the water from getting through the exhaust back to your motor.
Well it depends if u r mixing it through the canister in the back or the tank if the canister in the back just fill it up if u r mixing through the gas tank i mix mine 32:1 which is bout 4 oz to one gallon I've have my blaster sense 04 and haven't had problem with so i suggest mix 32:1
the last 2 digits on the hull number/code the hull number can be found on a plate above the exhaust exit on the back of the ski
In the exhaust on the back side of the engine.In the exhaust on the back side of the engine.
In the exhaust manifold on the back of the engine.In the exhaust manifold on the back of the engine.
In the exhaust pipe, at the back of the engine.In the exhaust pipe, at the back of the engine.
It is in the exhaust pipe on the back of the engine.It is in the exhaust pipe on the back of the engine.
They are screwed into the exhaust on the back side of the engine.They are screwed into the exhaust on the back side of the engine.
400 Chevy engine back firiung exhaust carburtor
Some (front wheel drive) cars have a flexible piece of pipe that connects the exhaust manifold to rest of the exhaust system. The length of pipe is designed to allow the engine to rock back and forth on its mounts. Without the flex joint, the movement of the engine would damage the rest of the exhaust system.
Exhaust.