Sure, but you also need to get the air out of the lines and the master cylinder. Put the slave on, then bleed the clutch keeping a supply of brake fluid in the reservoir.
The clutch can't be adjusted. It is an hydraulic clutch. The clutch pedal sends pressure from the master cylinder to the slave cylinder on the clutch. IF you are having trouble with it the thing to do is bleed the air out at the slave cylinder. Have an assistant pump the clutch and hold it to the floor. Then open the bleed valve on the slave cylinder to let the air out of the system. On the final bleed hold the clutch to the floor and close the bleed valve on the slave cylinder. The clutch master cylinder operates of the brake fluid reservoir. Make sure you keep this full of brake fluid as you bleed the clutch.
after the clutch master cylinder has been replaced.
FOR ME THERE IS NO WAY TO BLEED A CLUTCH ON A SATURN BUT IF YOU REPALCE ONE PART SOMETIME ITS POSSIBLE. 20 % CHANCE .THE ONLY WAY ITS TO REPLACE THE SLAVE AND THE CYLINDER AS A SEALED KIT
first check your clutch slave cylinder for leaks, if its leaking ,replace and bleed system,if its not leaking,bleed system ,dont forget to bleed clutch damperand if its still not right, then replace clutch master cylinder.
how do you bleed the clutch master cylinder in a 2005 mazda 3
On the clutch slave cylinder
Need to know how to assemble 95 Chevy clutch master cylinder?
To bleed a clutch on a Nissan Stanza, you need to find the bleed-off valve, usually somewhere near the slave cylinder.
Bleed the clutch line that runs from the clutch master cylinder to the slave cylinder utilizing the bleed valve on the slave cylinder.
shhould be da same way u bleed your break system... bleed valve on clutch master cylinder...
There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.
You bleed the clutch at the slave cylinder located near the transmission close to the radiator up front.