It is very possible for this to happen--if your fluid level gets low you can get air into the system that would make it difficult if not impossible to get your car in gear. I am surprized that no one on this formum could help you out sooner. Thamks Larry Foss
how much cost to change a clutch for a geo prizm 1995
Check your cable to make sure it's not kinked or bent somewhere and make sure it's adjusted correctly. If the clutch itself is sticking, you'll probably have to install a new one.
with just this info it's possible your a/c clutch bearings are going bad with just this info it's possible your a/c clutch bearings are going bad
It is located on the clutch slave cylinder. The slave cylinder is mounted on top of the transmission. Have someone push on the clutch cable and you will see movement on the cylinder.
prizm airconditioner not making room cool
it depends on what kind of cluch you want to go with,at a Chevy dealership you can get a Toyota clutch or a chevey clutch. I had to put in a new clutch in my 96 prism and it was a Toyota and it costed me about 800
Just find the cable on the transmission and look at it. The adjusting nut is where it connects to the tranny. You'll have to figure out which way to turn it for yourself.
I recently purchased a new clutch kit for a 1998 Prizm (which should be the same) from Oreilly Auto Parts for $99.00. This kit included the cluch plate, pressure plate and bearing. Hope that helps.
its probable that the clutch is going and the reason why it works after you start the car back up is your giving the clutch a chance to cool "if even for a second" and the fingers on the pressure plate extend back out enough to do you some good....look into having it replaced.
it is possible the wheel hub is damaged.
Geo Prizm was created in 1989.
My 1991 Geo Prizm LSI does not have overdrive My 1991 Geo Prizm LSI does not have overdrive