yes but you will have to change steering column for one with an automatic shifter and have the driveshaft shortened to accomidate the longer transmission you could also use a floor shifter hurst makes a good one
It is just attached with bolts to the floor board, lift the mats and you will see.
Passenger side under the glove box by the floor. Remove the panel you will see it.
In the cab, in front of the drivers seat on the floor is a plug(roughly 3"x5" plate) that you remove to gain access to the master cylinder. Once that plate is removed you will see the cab that turn's off so you can add fluid.
To remove the back seat on a 1989 Ford Thunderbird, the first step is to remove the back of the seat. The back is held in by bolts on each side. After the back is removed, the seat area should come out after removing the floor bolts.
I would say no , there is no listing for a 1965 Torino on the Ford website
what are the timing spec for a 1965 ford galixie
Diagram of ford 1965 289 engine
To remove the rear seat from a 1989 Ford Laser 4 door car, first remove the bolts anchoring the rear seat to the floor of the vehicle. Then, lift the bottom portion of the seat from the car. Then, remove the internal bolts from the hatchback or trunk of the car to remove the seat back.
The number of 1965 Ford Galaxie 500 convertibles that were produced is 31,930. The number of 1965 Ford Galaxie 500XL convertibles produced was 9,849.
Ford Transit was created in 1965.
You must remove the seat from the truck. It is attached to the floor of the cab with 4 bolts, I think. When you get the seat out, turn it over and you will see how the arm rest is attached.
where is the floor jack located on a 99 ford taurus