Turn it left to loosen, and do NOT overtighten because you don't want to ruin threads (they may be damaged if last person that installed pulley over-tightened it).
put your pp in the pistons
it is a 2001 Pontiac Montana that has broken three bealts so far I need to know what pully I will need to replace?
To change the serpentine belt on a 2003 Pontiac Bonneville, loosen the tensioner pulley and remove the old belt. The tensioner pulley is the wheel in the belt system that has a bolt through the middle in a slot that can be adjusted. Put the new belt on and tighten up the pulley.
You can tighten a fan belt by tightening the tensioner pulley. Pry to the left on the tensioner pulley and tighten it.
theres gonna either be a tensioner bolt or tensioner pulley... u should beable to locate waterpump, crank, a/c, alternator, powersteering,idle pulley. knowing the car woulda been easier
its loose tighten the pulley
yes a shoe lace is a pulley because it helps tighten things!
The power steering belt has an adjustment pulley. To tighten the belt on a 1994 Acura Vigor loosen the adjustment pulley and pull it up higher than tighten it.
All you do is look for the tension pulley and tighten it, see below
Open the hood. With your left hand, reach out and down a little. It's right above the water pump pulley. If it were a Bear, it would bite you. :p
Pulley above the crankshaft pulley (lowest on engine)
most cars have an adjuster pulley where you can tighten the belt and also replaceit as well.