Turn the bolt to the left to remove it.
Right hand thread
Right hand thread
Right hand thread
1998 Nissan pathfinder crankshaft pulley bolt is right handed.
More than likely it is right hand thread.
i am sure its left hand thread
crankshaft sensor is on the right rear corner drivers side of the engine.
on the right side of the engine
it is a regular bolt, turn right it tightens, turn left it loosens
It is right hand thread. Turn counter clockwise to loosen.
Any crankshaft is inside the engine bolted to the bottom of the engine block. Visually from the outside it would be in the center of the engine horizontally, right where the oil pan meets the engine block.
Its the normal right handed thraed... It IS torqued to about 120 ft lbs though... You may need to wedge the flexplate/flywheel to keep from spinning the entire rotating assembly when you try to loosen it.