NO!!!!!!!!!! actually it is quite likely. I had a similar vintage motor home with the 360cid and it did the same thing. the manifold bolts go through the water jacket. expect a lot of white steam on startup! Remember to refill and burp the radiator before starting!
The exhaust manifold on a Chevy S10 truck is changed by removing the spark plugs, unbolting the manifold from the cylinder heads, and unbolting the collector. The manifold can then be removed from the vehicle and a new set put in its place.
Yes, the exhaust manifold on a 99 Chevy S10 2.2 will need to be be removed during the blown head gasket repair.
You need to BClear. What Engine are we working with? In General the answer is no.
The intake manifold, head, and exhaust manifold must be removed to gain access to the gasket.
You Must take the exhaust off at the manifold.
The intake manifold and exhaust manifold must be removed. Then the head must be removed and the gasket replaced. The head must be checked for cracks and to see if it is warped. Then it is all put back together.
Its underneath exhaust manifold on driver side . Take loose 2 bolts pull pipe to firewall. some cases exhaust mainfold must be removed.
The intake & exhaust manifold must be removed. Then the head must must be removed. A very difficult repair and not a repair a novice should attempt.
The intake manifold, exhaust manifold, and head must be removed. This is a major repair that should only be done by someone with the knowledge and skill to perform it correctly.
The exhaust back pressure sensor on a 2006 6.0 diesel Ford F3 50 can be located near the exhaust manifold. The sensor is a probe that can be removed by loosening the nut.
Remove the upper radiator hose, carburetor, intake manifold, and exhaust manifold. There are lots of hoses and wires going to various devices on the intake manifold and around the engine that have to be removed also. Additionally the alternator, water pump, smog pump, etc. need to be removed.
Intake & exhaust manifold must be removed. Then the head must be removed. head inspected for cracks or warping, and new head gasket installed. Not a repair for a novice.