Crankcases and PCV Valves
Dodge Caravan
Dodge Grand Caravan

Is there a PCV valve on a 2000 Dodge Caravan?

161718

Top Answer
User Avatar
Wiki User
2011-09-13 06:06:56
2011-09-13 06:06:56

yes theres actually two different kinds to my knowledge. its really easy to see. its just straight, no elbow like most. the front valve cover should have a hose comin out of it. follow the hose a short way up. the other end LOOks to be just a fitting but its not. that's the pcv valve. it should either slip in or screw out. that's the difference between the two. one slips in. one screws in.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Center of the rear valve cover.

User Avatar

The valve is in the center of the rear valve cover.

User Avatar

The PCV just slips out and slips in; no tools required in most cases.

User Avatar

Yes, it is in the hose coming off of the rear valve cover.

User Avatar

valve cover on the top back of engine. its on top of the plastic valve cover.

User Avatar

On top of the intake cover on the right side.

User Avatar

Attached to the valve cover is a hose on the driver side. Unscrew the nut closest to the valve cover and that is the PCV valve. It is a straight PCV valve, not the elbow shape you may be looking for.

User Avatar

On the 3.3 its located on the rear valve cover. Theres a hose runnin strait to it, about mid cover.

User Avatar

On the 2.8 it's on top of the plenum at the back. disconnect the hose & unscrew the pcv valve & replace.

User Avatar

It might be that your pcv valve is plugged or the egr valve is sticking.

User Avatar

It is threaded into the valve cover. There is a rubber tube that attaches to the valve cover - pull off the tube (there may be a clamp) - then unscrew the PCV valve with a wrench.

User Avatar

On a 2000 Durango V8 the PCV is located on the side of the oil fill tube under the cap

User Avatar

open the hood, reach up and over the intake manifold, the PCV valve is right on the middle of the back valve cover. you should see a short rubber tube that comes out of the middle of the back valve cover and into the intake manifold. the plastic part that is screwed into the middle of the valve cover is the PCV valve..

User Avatar

Where is the pcv valve on 2007 dodge dakota 4.7 mag. Eng.and the egr valve also?

User Avatar

The PCV valve for a 2000 Blazer is mounted in the top of the valve cover. The valve plugs in and easily replaced.

User Avatar

Some of the 2000 models have a PCV valve on the back of the valve cover. The other models do not have a PCV valve, but use an oil/air separator instead.

User Avatar

I'm betting it's on the valve cover. There's a hose running from it to the air cleaner. It's an easy replacement and not very expensive.

User Avatar

The PCV valve is located in the valve cover, on the 4.7L it is in the side of the oil filler housing.

User Avatar

The PCV valve for a 2000 Lexus rx300 is on the passenger side of the engine. It is on the valve cover near the back.

User Avatar

The PCV valve on a 1991 Dodge Dynasty 3.0 engine is on the passenger side of the vehicle. It is on the crankcase.

User Avatar

The PCV valve on a 2000 V6 Camry is found near the engine. More specifically, it is located on the top of the valve cover.

User Avatar

The PCV valve is located in the rear valve cover,just behind the throttle body


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.