answersLogoWhite

0


Best Answer
Copy

It doesn't have a bolt. Just put the puller's collar around the pulley hub, and with a bit of effort, the pulley comes off. A lot of mechanics use an air impact to drive bolt for the puller.

User Avatar

Wiki User

โˆ™ 2004-12-18 06:01:35
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +5 pts
Q: Is there a bolt that has to be removed from the power steering pump pulley on a 90 Thunderbird in addition to needing the special puller?
Write your answer...
Submit

Related Questions

1992 thunderbird sc 3.8 liter car makes a loud noise but will not when power steering belt is removed you have replaced power steering pump to no avail you can find no pulley locked up please help?

change the idler pulley


How do you remove a 1963 nova steering gear box?

When removing steering box the steering wheel has to be removed steering shaft is not remove able it will have to slide down when steering box is removed ie then remove pit man arm and bolts from the frame


What will happen if you removed your power steering pump on your vehicle?

Then you won't have power steering.


How can you remove the steering of ford telstar 1993?

Use hacksaw! just cut the steering wheel and presto! you already removed your steering wheel


Replacing a lock cylinder for a 94 Ford Thunderbird?

You can replace the locking cylinder, on your 1994 Ford Thunderbird, by removing the inside door panel. The locking mechanism will be visible with the door panel removed.


How do you straighten a steering will on a f350?

The steering wheel will have to be removed, turned to the proper place, then reinstalled. If there is an air bag system it will have to be disconnected first.


How do you replace an Isuzu Rodeo steering wheel?

To replace an Isuza Rodeo steering the steering column should first be removed. Pop off the front steering wheel cover to see the steering wheel nut. Loosen the nut and remove the wheel.


How do you take the heater core out of a 1994 Thunderbird 4.6?

Bad news... Entire dash must be removed. My 1995 Thunderbird heater core failed in ealy December. Bypassed it. Dealer wants $800 for labor only.


Which part of the formula 1 car has to be removed for the driver to come out?

Steering wheel


How do you take steering wheel off a 93 Toyota Camry?

A steering wheel is hard to remove by hand. It can be removed with a tool called the steering wheel remover found at local auto shops.


How do you remove steering wheel Chevy Cavalier?

Removing a standard steering wheel from a Chevy Cavalier requires taking off the lower steering column and horn button. The steering wheel is held on by mounting screws, after removed be sure to unplug the horn wire.


How do you remove Renault clio steering wheel?

To remove the steering wheel from a Renault Clio one must first remove all screws from the back side of the steering column. Once all the screws are removed the steering wheel should be able to be wiggled free.


Why is your steering wheel not turning?

Two reason why your steering wheel is not turning.One....your ignition key is removed and you have turned the steering wheel to LOCK position.Two your front wheels are pinned against an obstacle so your front wheels are blocked.


Pontiac 2000 Montana is it hard to change power steering pump?

yes and no. with the amount of room, i rotated the motor, removed the battery, and partially removed the windshied wiper fluid resoviour. You must disconnect both hoses or the power steering pump will not come out. While you have the power steering pump out, you should replace the high pressure hose.


Steering wheel hard to turn in 1994 Lexus ls400?

1991 Lexus ls400 hard steering at ilde rack &pump have been replace all screencleaned or removed.


How do you remove the steering wheel from a 2005 Toyota Corolla?

To remove a steering wheel, a person will need a steering wheel puller from an auto part store, from there after the airbag is removed, place the tool over the steering wheel and follow its directions. It will pull the steering wheel off by applying pressure to the middle and pulling everything else up.


How do you change a water pump on a 1992 Camero RS 3.1L Does the power steering pump have to be removed?

yes it does


How do you remove the back seat on a 1989 Ford Thunderbird?

To remove the back seat on a 1989 Ford Thunderbird, the first step is to remove the back of the seat. The back is held in by bolts on each side. After the back is removed, the seat area should come out after removing the floor bolts.


How do you replace a turn single switch in a 1996 Chevy Lumina LS with a air bag the only why the blinker works is if you hold the switch?

Its a tough job that requires special tools. Remove the air bag. Remove the steering with a steering wheel puller. Remove the air bag position sensor. The steering wheel lock plate needs to be removed with a steering wheel lock plate puller. Then the turn signal switch can be removed by snaking the wire harness through the steering column. Not as easy as it sounds.


Steering column lock?

Steering columns commonly lock when the ignition key is removed. If the key doesn't want to turn and unlock the column, shake the steering wheel side to side to try and release it from the binding lock while turning the key.


Where is the OBDII connector on a 2007 Honda Accord?

It is located under the dash panel (which has to be removed) to the left of the steering column.


Removal of steering wheel 1994 Chevy S10 4x4 blazer?

I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck! I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck! I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck!


Do you need a special tool to remove the power steering reservoir cap?

There is no special tool needed to remove the power steering reservoir cap of a Volkswagen Golf. It can be removed with a flat head screwdriver.


How do you change the power steering pump reservoir on a2004 Chevy cavalier?

There are two bolts, two brackets, and a pressure hose which have to be removed in order to separate the power steering pump and the reservoir. The bolts are removed with a 13mm box end wrench, the brackets (top and bottom)of the reservoir are removed by using a flat head screwdriver to pry them loose. The pressure hose is removed by using pliers to decompress the ring clip around the end of the hose.


How do I change the power steering belt in a 1994 roadmaster?

Begin by loosening the tensioner pulley. Slide the tensioner pulley to the right. The power steering belt will become loose and can be removed. Put the new power steering belt on and tighten it by sliding the tensioner pulley to the left.